TY  - JOUR
A1  - Khodaverdi, M.
A1  - Chatziioannou, A. F.
A1  - Weber, S.
A1  - Ziemons, Karl
A1  - Halling, H.
A1  - Pietrzyk, U.
T1  - Investigation of different MicroCT scanner configurations by GEANT4 simulations
JF  - IEEE Transactions on Nuclear Science
N2  - This study has been performed to design the combination of the new ClearPET (ClearPET is a trademark of the Crystal Clear Collaboration), a small animal positron emission tomography (PET) system, with a micro-computed tomography (microCT) scanner. The properties of different microCT systems have been determined by simulations based on GEANT4. We will demonstrate the influence of the detector material and the X-ray spectrum on the obtained contrast. Four different detector materials (selenium, cadmium zinc telluride, cesium iodide and gadolinium oxysulfide) and two X-ray spectra (a molybdenum and a tungsten source) have been considered. The spectra have also been modified by aluminum filters of varying thickness. The contrast between different tissue types (water, air, brain, bone and fat) has been simulated by using a suitable phantom. The results indicate the possibility to improve the image contrast in microCT by an optimized combination of the X-ray source and detector material.
Y1  - 2005
SN  - 0018-9499
VL  - 52
IS  - 1
SP  - 188
EP  - 192
ER  - 
TY  - JOUR
A1  - Mang, Thomas
A1  - Kolz, J.
A1  - Martins, J.
A1  - Kremer, K.
T1  - Investigation of Elastomer Foams by Single-Sided NMR / Kolz, J. ; Martins, J. ; Kremer, K. ; Blümich, B. ; Mang, Thomas
JF  - Kurzfassungen : 3. bis 6. Juli 2006, Nürnberg = Summaries / Deutsche Kautschuk Tagung, 3.7.-6.7.2006
Y1  - 2006
N1  - Deutsche Kautschuk-Tagung ; <2006, Nürnberg >
SP  - 33
PB  - DKG, Dt. Kautschuk-Ges.
CY  - Frankfurt, Main
ER  - 
TY  - CHAP
A1  - Reisgen, Uwe
A1  - Schleser, Markus
A1  - Abdurakhmanov, Aydemir
A1  - Turichin, Gleb
A1  - Valdaitseva, Elena
A1  - Bach, Friedrich-Wilhelm
A1  - Hassel, Thomas
A1  - Beniyashi, Alexander
T1  - Investigation of factors for defect-free weld formation by non-vacuum electron beam welding
T2  - Laser technologies in welding and materials processing : proceedings of the fifth international conference, 24 - 27 May 2011, Katsiveli, Crimea, Ukraine
Y1  - 2011
SP  - 104
EP  - 109
PB  - Paton Publ. House
CY  - Kiev
ER  - 
TY  - JOUR
A1  - Reisgen, Uwe
A1  - Schleser, Markus
A1  - Abdurakhmanov, Aydemir
A1  - Turichin, Gleb
A1  - Valdaitseva, Elena
A1  - Bach, Friedrich-Wilhelm
A1  - Hassel, Thomas
A1  - Beniyashi, Alexander
T1  - Investigation of factors influencing the formation of weld defects in non-vacuum electron beam welding
JF  - The Paton welding journal
N2  - The influence of welding condition parameters and properties of material on formation of defects, such as humping and undercuts, in non-vacuum electron beam welding was investigated. The influence of separate welding parameters on the quality of welds was determined.
Y1  - 2012
SN  - 0957-798X
VL  - 2012
IS  - 2
SP  - 11
EP  - 18
PB  - Paton Publishing House
CY  - Kiev
ER  - 
TY  - JOUR
A1  - Schwarzer, Klemens
A1  - Schlenger, Barbara J.
T1  - Investigation of fission product aerosol behavior in an HTR containment during severe core-heatup accidents / Barbara J. Schlenger ; K. Schwarzer
JF  - Tagungsbericht : Maritim Kongresszentrum, 17. - 19. Mai '88 Travemünde / Kerntechnische Gesellschaft e.V.; Deutsches Atomforum e.V. [Red.: K. G. Bauer]
Y1  - 1988
SN  - 0720-9207
N1  - Jahrestagung Kerntechnik <1988, Lübeck-Travemünde> ; Annual Meeting of Nuclear Technology <1988, Lübeck-Travemünde>
SP  - 179
EP  - 182
PB  - Inforum
CY  - Bonn
ER  - 
TY  - CHAP
A1  - Weiss, Alexander
A1  - Abanteriba, Sylvester
A1  - Esch, Thomas
T1  - Investigation of Flow Separation Inside a Conical Rocket Nozzle With the Aid of an Annular Cross Flow
T2  - Proceedings of the ASME/JSME 2007 5th Joint Fluids Engineering Conference. Volume 1: Symposia, Parts A and B
N2  - Flow separation is a phenomenon that occurs in all kinds of supersonic nozzles sometimes during run-up and shut-down operations. Especially in expansion nozzles of rocket engines with large area ratio, flow separation can trigger strong side loads that can damage the structure of the nozzle. The investigation presented in this paper seeks to establish measures that may be applied to alter the point of flow separation. In order to achieve this, a supersonic nozzle was placed at the exit plane of the conical nozzle. This resulted in the generation of cross flow surrounding the core jet flow from the conical nozzle. Due to the entrainment of the gas stream from the conical nozzle the pressure in its exit plane was found to be lower than that of the ambient. A Cold gas instead of hot combustion gases was used as the working fluid. A mathematical simulation of the concept was validated by experiment. Measurements confirmed the simulation results that due to the introduction of a second nozzle the pressure in the separated region of the conical nozzle was significantly reduced. It was also established that the boundary layer separation inside the conical nozzle was delayed thus allowing an increased degree of overexpansion. The condition established by the pressure measurements was also demonstrated qualitatively using transparent nozzle configurations.
Y1  - 2007
SN  - 0-7918-4288-6
U6  - https://doi.org/10.1115/FEDSM2007-37387
N1  - Proceedings of the ASME/JSME 2007 5th Joint Fluids Engineering Conference. Volume 1: Symposia, Parts A and B. San Diego, California, USA. July 30–August 2, 2007
SP  - 1861
EP  - 1871
PB  - American Society of Mechanical Engineers (ASME)
CY  - New York
ER  - 
TY  - CHAP
A1  - Huber, Frédéric
A1  - Bleck, Wolfgang
A1  - Scheik, Sven
A1  - Schleser, Markus
A1  - Reisgen, Uwe
T1  - Investigation of galvanneal coating adherence in adhesive bonded joints using lap shear test
T2  - Galvatech 2011 : 8th International Conference on Zinc and Zinc Alloy Coated Steel Sheet, June 21 - 24, 2011, Genova (Italy) ; proceedings
Y1  - 2011
SN  - 978-88-85298-82-8
SP  - Paper No. 43
PB  - Associazione Italiana di Metallurgia
CY  - Mailand
ER  - 
TY  - JOUR
A1  - Müller-Veggian, Mattea
A1  - Gono, Y.
A1  - Lieder, R. M.
A1  - Mayer-Böricke, C.
T1  - Investigation of high spin states and isomers in ¹³⁶,¹³⁷ Ce
JF  - Frühjahrstagung ... des Fachausschusses Kernphysik und Hochenergiephysik der DPG (Sektion A: Kernphysik) / Deutsche Physikalische Gesellschaft. 11 (1976)
Y1  - 1976
N1  - Verhandlungen der Deutschen Physikalischen Gesellschaft ; 1976=6.R.11,8
SP  - 911
EP  - 912
ER  - 
TY  - JOUR
A1  - Müller-Veggian, Mattea
A1  - Neskakis, A.
A1  - Lieder, R. M.
A1  - Beuscher, H.
T1  - Investigation of high-spin states in odd-odd ¹⁹⁰,¹⁹²,¹⁹⁴ Au nuclei
JF  - Nuclear physics / A, Nuclear and hadronic physics. 290 (1982), H. 1
Y1  - 1982
SN  - 0375-9474
SP  - 53
EP  - 69
ER  - 
TY  - JOUR
A1  - Müller-Veggian, Mattea
A1  - Beuscher, H.
A1  - Haenni, D. R.
T1  - Investigation of high-spin states in ¹³⁸,¹³⁹ Nd
JF  - Structure of medium-heavy nuclei, 1979 : proceedings of the 6. European Physical Soc. Nuclear Divisional Conference on the Structure of Medium-Heavy Nuclei held in Rhodes, Greece, 1-4 May 1979 / ed. Committee: G. S. Anagnostatos ... - (Conference series / Institute of Physics London, Bristol ; 49)
Y1  - 1980
SN  - 0-85498-140-3
N1  - Conference on the Structure of Medium Heavy Nuclei <6, 1979, Rodos> ; European Physical Society / Nuclear Physics Division
SP  - 112
PB  - Inst. of Physics
CY  - Bristol
ER  -