TY - JOUR A1 - Kern, Alexander A1 - Zischank, Wolfgang J. T1 - The effect of parallel wires on the longitudinal voltage drop along shielded cables JF - Conference proceedings : 21st International Conference on Lightning Protection, Berlin Congress Center (BCC) Germany, September 22 - 25, 1992 = 21. Internationale Blitzschutzkonferenz / [proceedings ed. staff: J. Pilling ...] Y1 - 1992 SN - 3-8007-1885-5 N1 - International Conference on Lightning Protection <21, 1992, Berlin> ; ICLP <21, 1992, Berlin> PB - VDE-Verl. CY - Berlin [u.a.] ER - TY - JOUR A1 - Förster, Arnold A1 - Layet, J. M. A1 - Lüth, H. T1 - The effect of inhomogeneous dopant profiles on the electron energy loss spectra of Si(100) / JF - Applied Physics A: Materials Science & Processing. 47 (1988), H. 1 Y1 - 1988 SN - 0947-8396 N1 - ISSN der E-Ausg.: 1432-0630 SP - 95 EP - 97 ER - TY - JOUR A1 - Förster, Arnold A1 - Lange, J. A1 - Gerthsen, D. T1 - The effect of growth temperature on AlAs/GaAs resonant tunnelling diodes JF - Journal of Physics D: Applied Physics. 27 (1994), H. 1 Y1 - 1994 SN - 0022-3727 N1 - ISSN der E-Ausg.: 1361-6463 SP - 175 EP - 178 ER - TY - JOUR A1 - Hardt, Arno A1 - Martin, S. A1 - Meißburger, J. A1 - Retz, R. A1 - Wimmer, J. T1 - The cryopump system of the QQDDQ magnet spectrometer BIG KARL JF - Vacuum N2 - Cryopumps without liquid nitrogen shielding are used to provide a vacuum of 10−6 torr in the spectrometer. The vacuum system is subdivided in three sections that can be separated by valves. The first section (scattering chamber) has a volume of 60 l, two rotation transmissions with 35 cm dia and a sliding seal that allows a rotation of 160° without deteriorating the vacuum. The second section includes the vacuum chambers inside the magnets with 6 × 80 cm cross-section and a length of 1200 cm. The third section (detector box) has a volume of 4300 l and contains a moveable detector system. The gas inside the detector with a pressure of 760 torr is separated from the vacuum by a 15 μm mylar foil with an area of 300 cm2. The detector box can be valved off by a valve with the dimension of 10 × 100 cm. The layout of system is given. The instrumentation and the interlock system are described. First experiences with this system are presented. Y1 - 1978 U6 - https://doi.org/10.1016/S0042-207X(78)80026-8 SN - 1879-2715 (E-Journal); 0042-207X (Print) VL - 28 IS - 10-11 SP - 483 PB - Elsevier CY - Amsterdam ER - TY - JOUR A1 - Kahmann, Stephanie L. A1 - Rausch, Valentin A1 - Plümer, Jonathan A1 - Müller, Lars P. A1 - Pieper, Martin A1 - Wegmann, Kilian T1 - The automized fracture edge detection and generation of three-dimensional fracture probability heat maps JF - Medical Engineering & Physics N2 - With proven impact of statistical fracture analysis on fracture classifications, it is desirable to minimize the manual work and to maximize repeatability of this approach. We address this with an algorithm that reduces the manual effort to segmentation, fragment identification and reduction. The fracture edge detection and heat map generation are performed automatically. With the same input, the algorithm always delivers the same output. The tool transforms one intact template consecutively onto each fractured specimen by linear least square optimization, detects the fragment edges in the template and then superimposes them to generate a fracture probability heat map. We hypothesized that the algorithm runs faster than the manual evaluation and with low (< 5 mm) deviation. We tested the hypothesis in 10 fractured proximal humeri and found that it performs with good accuracy (2.5 mm ± 2.4 mm averaged Euclidean distance) and speed (23 times faster). When applied to a distal humerus, a tibia plateau, and a scaphoid fracture, the run times were low (1–2 min), and the detected edges correct by visual judgement. In the geometrically complex acetabulum, at a run time of 78 min some outliers were considered acceptable. An automatically generated fracture probability heat map based on 50 proximal humerus fractures matches the areas of high risk of fracture reported in medical literature. Such automation of the fracture analysis method is advantageous and could be extended to reduce the manual effort even further. KW - Fracture classification KW - Shoulder KW - Probability distribution mapping KW - Morphing KW - Imaging Y1 - 2022 SN - 1350-4533 VL - 2022 IS - 110 PB - Elsevier CY - Amsterdam ER - TY - JOUR A1 - Förster, Arnold A1 - Spitzer, A. A1 - Lüth, H. T1 - The adsorption of fluor-carbon complexes on GaAs(110) studied by electron energy loss spectroscopy JF - Surface Science. 172 (1986), H. 1 Y1 - 1986 SN - 0039-6028 N1 - ISSN der E-Ausg.: 0039-6028 SP - 174 EP - 182 ER - TY - JOUR A1 - Hoyler, Friedrich A1 - Drissi, S. A1 - Tercier, P. A. T1 - The 112Cd laboratory - An extension : EO strengths, multiphonon states and coupled vibrations / S. Drissi ; P. A. Tercier ... F. Hoyler ... JF - Nuclear physics / A. 614 (1997), H. 2 Y1 - 1997 SN - 0375-9474 SP - 137 EP - 182 ER - TY - JOUR A1 - Schwarzer, Klemens A1 - Faber, C. A1 - Stracke, T. T1 - Teststelle fuer Warmwasser-Kollektoren und -Systeme JF - Energiewirtschaftliche Tagesfragen. 44 (1994), H. 9 Y1 - 1994 SN - 0720-6240 N1 - Zusammenarbeit mit dem tunesischen Forschungsinstitut INRST SP - 41 EP - 43 ER - TY - JOUR A1 - Schwarzer, Klemens A1 - Stracke, Thomas T1 - Teststand für solarthermische Kollektoren JF - Energie für die Zukunft : 28. Juni bis 1. Juli 1994 ; [Tagungsbericht 1] / 9. Internationales Sonnenforum '94. [Hrsg. Deutsche Gesellschaft für Sonnenenergie e.V. - DGS. Red. A. Hohmann ; H. H. Hohmann]. - (Internationales Sonnenforum ; 9,1) Y1 - 1994 N1 - Internationales Sonnenforum <9, 1994, Stuttgart> ; Deutsche Gesellschaft für Sonnenenergie SP - 319 EP - 326 PB - DGS-Sonnenenergie CY - München ER - TY - JOUR A1 - Schwarzer, Klemens A1 - Bieger, W. T1 - Tests von solaren Brauchwassersystemen / W. Bieger ; K. Schwarzer JF - Erneuerbare Energiequellen : Aktivitäten deutscher Hochschulen / zsgest. von F. A. Peuser ... Y1 - 1987 SP - 6 EP - 7 PB - Zentralstelle für Solartechnik CY - Hilden ER -