TY - CHAP A1 - Kuhnhenne, Markus A1 - Feldmann, Markus A1 - Döring, Bernd A1 - Spranger, Sascha T1 - Luftdichtheit im Stahlleichtbau - Gebäudehüllen in Sandwichbauweise T2 - Dichte Gebäudehülle, Thermografie und Wohnungslüftung : 2. Europäisches BlowerDoor-Symposium : 16.3. - 17.3. 2007, Kassel Y1 - 2007 SP - 121 EP - 134 PB - Energie + Umwelt-Zentrum ER - TY - CHAP A1 - Dachwald, Bernd T1 - Low-Thrust Mission Analysis and Global Trajectory Optimization Using Evolutionary Neurocontrol: New Results T2 - European Workshop on Space Mission Analysis ESA/ESOC, Darmstadt, Germany 10 { 12 Dec 2007 N2 - Interplanetary trajectories for low-thrust spacecraft are often characterized by multiple revolutions around the sun. Unfortunately, the convergence of traditional trajectory optimizers that are based on numerical optimal control methods depends strongly on an adequate initial guess for the control function (if a direct method is used) or for the starting values of the adjoint vector (if an indirect method is used). Especially when many revolutions around the sun are re- quired, trajectory optimization becomes a very difficult and time-consuming task that involves a lot of experience and expert knowledge in astrodynamics and optimal control theory, because an adequate initial guess is extremely hard to find. Evolutionary neurocontrol (ENC) was proposed as a smart method for low-thrust trajectory optimization that fuses artificial neural networks and evolutionary algorithms to so-called evolutionary neurocontrollers (ENCs) [1]. Inspired by natural archetypes, ENC attacks the trajectoryoptimization problem from the perspective of artificial intelligence and machine learning, a perspective that is quite different from that of optimal control theory. Within the context of ENC, a trajectory is regarded as the result of a spacecraft steering strategy that maps permanently the actual spacecraft state and the actual target state onto the actual spacecraft control vector. This way, the problem of searching the optimal spacecraft trajectory is equivalent to the problem of searching (or "learning") the optimal spacecraft steering strategy. An artificial neural network is used to implement such a spacecraft steering strategy. It can be regarded as a parameterized function (the network function) that is defined by the internal network parameters. Therefore, each distinct set of network parameters defines a different network function and thus a different steering strategy. The problem of searching the optimal steering strategy is now equivalent to the problem of searching the optimal set of network parameters. Evolutionary algorithms that work on a population of (artificial) chromosomes are used to find the optimal network parameters, because the parameters can be easily mapped onto a chromosome. The trajectory optimization problem is solved when the optimal chromosome is found. A comparison of solar sail trajectories that have been published by others [2, 3, 4, 5] with ENC-trajectories has shown that ENCs can be successfully applied for near-globally optimal spacecraft control [1, 6] and that they are able to find trajectories that are closer to the (unknown) global optimum, because they explore the trajectory search space more exhaustively than a human expert can do. The obtained trajectories are fairly accurate with respect to the terminal constraint. If a more accurate trajectory is required, the ENC-solution can be used as an initial guess for a local trajectory optimization method. Using ENC, low-thrust trajectories can be optimized without an initial guess and without expert attendance. Here, new results for nuclear electric spacecraft and for solar sail spacecraft are presented and it will be shown that ENCs find very good trajectories even for very difficult problems. Trajectory optimization results are presented for 1. NASA's Solar Polar Imager Mission, a mission to attain a highly inclined close solar orbit with a solar sail [7] 2. a mission to de ect asteroid Apophis with a solar sail from a retrograde orbit with a very-high velocity impact [8, 9] 3. JPL's \2nd Global Trajectory Optimization Competition", a grand tour to visit four asteroids from different classes with a NEP spacecraft Y1 - 2007 ER - TY - CHAP A1 - Dilthey, Ulrich A1 - Schleser, Markus A1 - Hegger, Josef A1 - Voss, Stefan ED - Reinhardt, Hans W. T1 - Load-bearing behaviour of polymer-impregnated textiles in concrete T2 - Fifth International Workshop on High Performance Fiber Reinforced Cement Composites (HPFRCC 5) : Mainz, July 10 - 13, 2007. (RILEM proceedings. 53) Y1 - 2007 SN - 978-2-35158-046-2 SP - 183 EP - 192 PB - RILEM Publ. CY - Bagneux ER - TY - CHAP A1 - Weßling, Matthias T1 - Leadership Perspectives: Research Findings, Theories, Practical Experiences N2 - Leadership Perspectives: Research Findings, Theories, Practical Experiences: Results of Leadership Research and exemplarily application cases show the perspectives and consequences for leadership practice and the following requirements for executives in future. N2 - Leadership Perspectives: Research Findings, Theories, Practical Experiences: Bisherige Ergebnisse der betriebswirtschaftlichen Führungsforschung und exemplarische Anwendungsbeispiele der Führungspraxis, sowie die Schlußfolgerungen für die Perspektiven der betrieblichen Mitarbeiterführung sowie die sich daraus ergebenden Anforderungen an zukünftige Führungskräfte. KW - Leadership KW - Führung KW - Führungsansätze KW - Leadership KW - Self-Leadership KW - Leadership Approaches KW - Skill Assessment KW - Leadership Theories Y1 - 2007 ER - TY - CHAP A1 - Weiss, Alexander A1 - Abanteriba, Sylvester A1 - Esch, Thomas T1 - Investigation of Flow Separation Inside a Conical Rocket Nozzle With the Aid of an Annular Cross Flow T2 - Proceedings of the ASME/JSME 2007 5th Joint Fluids Engineering Conference. Volume 1: Symposia, Parts A and B N2 - Flow separation is a phenomenon that occurs in all kinds of supersonic nozzles sometimes during run-up and shut-down operations. Especially in expansion nozzles of rocket engines with large area ratio, flow separation can trigger strong side loads that can damage the structure of the nozzle. The investigation presented in this paper seeks to establish measures that may be applied to alter the point of flow separation. In order to achieve this, a supersonic nozzle was placed at the exit plane of the conical nozzle. This resulted in the generation of cross flow surrounding the core jet flow from the conical nozzle. Due to the entrainment of the gas stream from the conical nozzle the pressure in its exit plane was found to be lower than that of the ambient. A Cold gas instead of hot combustion gases was used as the working fluid. A mathematical simulation of the concept was validated by experiment. Measurements confirmed the simulation results that due to the introduction of a second nozzle the pressure in the separated region of the conical nozzle was significantly reduced. It was also established that the boundary layer separation inside the conical nozzle was delayed thus allowing an increased degree of overexpansion. The condition established by the pressure measurements was also demonstrated qualitatively using transparent nozzle configurations. Y1 - 2007 SN - 0-7918-4288-6 U6 - http://dx.doi.org/10.1115/FEDSM2007-37387 N1 - Proceedings of the ASME/JSME 2007 5th Joint Fluids Engineering Conference. Volume 1: Symposia, Parts A and B. San Diego, California, USA. July 30–August 2, 2007 SP - 1861 EP - 1871 PB - American Society of Mechanical Engineers (ASME) CY - New York ER - TY - CHAP A1 - Dilthey, Ulrich A1 - Schleser, Markus A1 - Puterman, Moshe T1 - Investigation and improvement of concrete reinforced with epoxy impregnated fabrics T2 - Proceedings / 12th International Congress Polymers in Concrete, ICPIC 07, chuncheon, Korea, Sept. 26. - 28., 2007 Y1 - 2007 SN - 978-89-9600450-9 SP - 725 EP - 733 PB - Kangwoon National Univ. CY - Chancheon ER - TY - CHAP A1 - Rohde, Raju M. T1 - Integrierte Implizite Kanalnetzberechnung mit BaSYS-HydroCAD N2 - Dr.-Ing. Raju M. Rohde , Dorsch Consult Wasser und Umwelt GmbH, München mit 32 Folien (S. 103-134). Beitrag zum 1. Aachener Softwaretag in der Wasserwirtschaft <1, 2007, Aachen>. Das System BaSYS.L.E.O. Ganglinien-Volumen-Methode Hydrodynamische Kanalnetzberechnung Hydraulische Objekte Hydrodynamische Schmutzfrachtberechnung KW - Kanalisation KW - Kanalnetz KW - Kanalnetzberechnung Y1 - 2007 ER - TY - CHAP A1 - Schleser, Markus A1 - Dilthey, Ulrich A1 - Mund, F. A1 - Böhm, Stefan ED - Czarnecki, Lech ED - Garbacz, Andrzej T1 - Improvement of textile reinforced concrete by use of polymers T2 - Adhesion in interfaces of building materials: a multi-scale approach : [Symposium "Adhesion in Building Bonds: Macro-, Micro- and Nano-Scale" at Warsaw University of Technology in the framework of the European Materials Research Society, fall meeting 2005 ; selected papers]. (Advances in materials science and restoration. No. 2) Y1 - 2007 SN - 978-3-931681-89-0 SP - 153 EP - 162 PB - Aedificatio Publ. CY - Freiburg ER - TY - CHAP A1 - Hecker, Dirk T1 - Hochwasservorsorge für Abwasseranlagen (DWA-M103) und öffentliche Einrichtungen N2 - Dipl.-Ing. Dirk Hecker von der Ingenieurgesellschaft Tuttahs & Meyer in Aachen. Vortrag gehalten beim 1. Aachener Softwaretag in der Wasserwirtschaft <1, 2007, Aachen> 27 S. (S. 28-54) Zusammenfassung [des Autors]: Nach den spektakulären Hochwasserereignissen an Rhein, Elbe und Donau hat die Deutsche Vereinigung für Wasserwirtschaft, Abwasser und Abfall e. V. (DWA) einen Fachausschuss zur Erstellung eines Merkblattes M 103 „Hochwasserschutz für Abwasseranlagen“ berufen. Das Merkblatt zeigt in den Kapiteln Konzeption, Planungsgrundsätze und Hochwassermanagement eine strukturierte Vorgehensweise zur bestmöglichen Vorsorge zum Schutz der Abwasseranlagen im Hochwasserfall. Entsprechend den Forderungen des im Jahr 2005 verabschiedeten Gesetzes zur Verbesserung des vorbeugenden Hochwasserschutzes, floss in das Wasserhaushaltsgesetz unter anderem die allgemeine Verpflichtung jedes potentiell vom Hochwasser Betroffenen ein, geeignete Schutzmaßnahmen zur Schadensminimierung zu treffen. Hierbei werden speziell die Wasserversorgung und die Abwasserbeseitigung erwähnt. Im DWA-M 103 wir detailliert dargestellt wie und mit welchem Aufwand die Abwasseranlagen zu überprüfen sind und wie hierzu ein Hochwasserschutzkonzept erstellt werden kann. Zusätzlich werden Hinweise für die Planung von Abwasseranlagen in hochwassergefährdeten Bereichen gegeben, die den störungsfreien Betrieb im Hochwasserfall gewährleisten sollen. Schlussendlich werden das Hochwassermanagement und der Betrieb dargestellt und hier wichtige Anregungen gegeben im Ernstfall ausreichend vorbereitet zu sein. Das DWA-M 103 richtet sich in erster Linie an die Betreiber und Planer von Abwasseranlagen. Jedoch werden hier auch, gerade durch die Vielzahl von Checklisten, Kommunen Denkanstöße und Anregungen für die Hochwasservorsorge/-schutz von öffentlichen Gebäuden und Einrichtungen gegeben. KW - Hochwasserschutz KW - Abwasseranlage KW - Hochwasservorsorge KW - Abwasseranlage Y1 - 2007 ER - TY - CHAP A1 - Lohr, Jürgen T1 - High Quality Streaming und High Definition Media Services N2 - In: Konferenzband zur Konferenz Medienproduktion 2007, 1.12.2008. 29 S. High Quality Streaming beschäftigt sich mit High Definition Television und Mehrkanal Sound. In diesem Beitrag werden die Technologien und Anwendungsperspektiven für HD Medien-Dienstleistungen beschrieben. Der Beitrag entstand im Rahmen der Konferenz Medienproduktion „Expansion und Mobilität“ am 7. Dezember 2007. Der Beitrag beschreibt Geschäftsmodelle, Technologien und neue Anwendungen für High Quality Streaming. Neben der Präsentation wurden auch die Medienproduktionen der unterschiedlichen HQ-Mediendienste vorgeführt. Die Mediendienste sind im Rahmen der Forschungsarbeit High Quality Media Services des Studiengangs Communication and Multimedia Design (Fachbereich Elektrotechnik und Informationstechnik) an der Fachhochschule Aachen entstanden. Eine Marktevaluierung der deutschen und niederländischen Märkte, internationale Expertengesprächen sowie ein Prototypen HDMediaservices bilden die Basis der Forschungsarbeit. Die Mediendienste stehen zur Demonstration unter dem Link media.fh-aachen.de bereit. HQ-Mediendienste bedeuten: Gestochen scharfe Bilder in High Definition, volle Klänge in Surround und das über das Internet, wo doch gerade mal die briefmarkengroßen Bilder mit unscharfen Konturen und krätzenden Klängen der heutigen Portale wie YouTube Alltag sind. KW - HDTV KW - High Quality Streaming KW - High Definition Media Services Y1 - 2007 ER -