TY - JOUR A1 - Finger, Felix T1 - Vergleichende Leistungs- und Nutzenbewertung von VTOL- und CTOL-UAVs JF - Luft- und Raumfahrt : informieren, vernetzen, fördern / Hrsg.: Deutsche Gesellschaft für Luft- und Raumfahrt Y1 - 2017 SN - 0173-6264 VL - 38 IS - 1 SP - 44 EP - 47 ER - TY - JOUR A1 - Esch, Thomas A1 - Saupe, T. A1 - Fahl, E. A1 - Koch, F. T1 - Verbrauchseinsparung durch bedarfsgerechten Antrieb der Nebenaggregate JF - Motortechnische Zeitschrift. 55 (1994), H. 7/8 Y1 - 1994 SN - 0024-8525 SP - 416 EP - 431 ER - TY - JOUR A1 - Esch, Thomas A1 - Wolters, P. A1 - Salber, W. A1 - Geiger, J. T1 - Variable Ventilsteuerung und Direkteinspritzung - vom Wettbewerb zur Synergie JF - Motor und Umwelt 2001, Internal Combustion Engine Versus Fuel Cell - Potential and Limitations as Automotive Power Sources, Verbrennungsmotor versus Brennstoffzelle - Potenziale und Grenzen für den Automobilantrieb, Proc., Graz, AT, 6.-7. Sep, 2001 Y1 - 2001 N1 - Konferenz-Einzelbericht SP - 183 EP - 206 ER - TY - JOUR A1 - Esch, Thomas A1 - Göbel, T. A1 - Pischinger, M. T1 - Variable Ventilsteuerung - Luft- und Kraftstoffzumessung bei Ottomotoren mit variabler Ventilsteuerung JF - Forschungsberichte Verbrennungskraftmaschinen. 578 (1995) Y1 - 1995 N1 - Report SP - 1 EP - 42 ER - TY - JOUR A1 - German, Laura A1 - Mikucki, Jill A. A1 - Welch, Susan A. A1 - Welch, Kathleen A. A1 - Lutton, Anthony A1 - Dachwald, Bernd A1 - Kowalski, Julia A1 - Heinen, Dirk A1 - Feldmann, Marco A1 - Francke, Gero A1 - Espe, Clemens A1 - Lyons, W. Berry T1 - Validation of sampling antarctic subglacial hypersaline waters with an electrothermal ice melting probe (IceMole) for environmental analytical geochemistry JF - International Journal of Environmental Analytical Chemistry N2 - Geochemical characterisation of hypersaline waters is difficult as high concentrations of salts hinder the analysis of constituents at low concentrations, such as trace metals, and the collection of samples for trace metal analysis in natural waters can be easily contaminated. This is particularly the case if samples are collected by non-conventional techniques such as those required for aquatic subglacial environments. In this paper we present the first analysis of a subglacial brine from Taylor Valley, (~ 78°S), Antarctica for the trace metals: Ba, Co, Mo, Rb, Sr, V, and U. Samples were collected englacially using an electrothermal melting probe called the IceMole. This probe uses differential heating of a copper head as well as the probe’s sidewalls and an ice screw at the melting head to move through glacier ice. Detailed blanks, meltwater, and subglacial brine samples were collected to evaluate the impact of the IceMole and the borehole pump, the melting and collection process, filtration, and storage on the geochemistry of the samples collected by this device. Comparisons between melt water profiles through the glacier ice and blank analysis, with published studies on ice geochemistry, suggest the potential for minor contributions of some species Rb, As, Co, Mn, Ni, NH4+, and NO2−+NO3− from the IceMole. The ability to conduct detailed chemical analyses of subglacial fluids collected with melting probes is critical for the future exploration of the hundreds of deep subglacial lakes in Antarctica. Y1 - 2021 U6 - http://dx.doi.org/10.1080/03067319.2019.1704750 SN - 0306-7319 VL - 101 IS - 15 SP - 2654 EP - 2667 PB - Taylor & Francis CY - London ER - TY - JOUR A1 - Blome, Hans-Joachim A1 - Priester, Wolfgang T1 - Vacuum energy in cosmic dynamics JF - Astrophysics and Space Science. 117 (1985), H. 2 Y1 - 1985 SN - 0004-640X SP - 327 EP - 335 ER - TY - JOUR A1 - Blome, Hans-Joachim A1 - Priester, Wolfgang T1 - Urknall und Evolution des Kosmos. II. Inflationär modifizierter Urknall und Eschatologie des Kosmos JF - Naturwissenschaften. 71 (1984), H. 10 Y1 - 1984 SN - 0028-1042 SP - 515 EP - 527 ER - TY - JOUR A1 - Blome, Hans-Joachim A1 - Priester, Wolfgang T1 - Urknall und Evolution des Kosmos. I. Einstein-Friedmann-Kosmos und das Neutrino-Problem JF - Naturwissenschaften. 71 (1984), H. 9 Y1 - 1984 SN - 0028-1042 SP - 456 EP - 467 ER - TY - JOUR A1 - Röth, Thilo A1 - Pielen, Michael A1 - Wolff, Klaus A1 - Lüdiger, Thomas T1 - Urbane Fahrzeugkonzepte für die Shared Mobility JF - Automobiltechnische Zeitschrift - ATZ N2 - Urbane Mobilitätskonzepte der Zukunft erfordern neue Unternehmensformen, idealerweise aus Old Economy und New Economy, sowie eine enge Anbindung an die gesellschaftsrelevante Zukunftsforschung. Für neue Fahrzeugkonzepte des Carsharing bedeutet dies, dass alle kostenverursachenden Faktoren erfasst und analysiert werden müssen. Die FH Aachen, share2drive und FEV geben einen Ausblick auf die zukünftige Fahrzeugklasse der Personal Public Vehicles als „Rolling Device“. Y1 - 2018 U6 - http://dx.doi.org/10.1007/s35148-017-0176-8 SN - 0001-2785 VL - 120 IS - 1 SP - 18 EP - 23 PB - Springer Vieweg CY - Wiesbaden ER - TY - JOUR A1 - Wittmann, Klaus A1 - Gillessen, F. A1 - Otto, G. A1 - Röstel, R. T1 - Undercooling and solidification of metallic melts suspended in a non-nucleating matrix: Experiment NUCAL of the German Spacelab Mission D-2 JF - Acta Astronautica. 38 (1996), H. 1 Y1 - 1996 SN - 0094-5765 SP - 63 EP - 68 ER - TY - JOUR A1 - Esch, Thomas T1 - Trends in der Nutzfahrzeugantriebstechnik JF - Motortechnische Zeitschrift (MTZ) Y1 - 2010 SN - 0024-8525 U6 - http://dx.doi.org/10.1007/bf03225608 VL - 71 IS - 10 SP - 652 EP - 658 PB - Springer Nature CY - Basel ER - TY - JOUR A1 - Esch, Thomas T1 - Trends in commercial vehicle powertrains JF - ATZautotechnology N2 - Low emission zones and truck bans, the rising price of diesel and increases in road tolls: all of these factors are putting serious pressure on the transport industry. Commercial vehicle manufacturers and their suppliers are in the process of identifying new solutions to these challenges as part of their efforts to meet the EEV (enhanced environmentally friendly vehicle) limits, which are currently the most robust European exhaust and emissions standards for trucks and buses. KW - European Transient Cycle KW - Common Rail Injection System KW - Commercial Vehicle KW - Selective Catalytic Reduction KW - Diesel Engine Y1 - 2010 U6 - http://dx.doi.org/10.1007/BF03247185 SN - 2192-886X VL - 2010 IS - 10 SP - 26 EP - 31 PB - Vieweg & Sohn CY - Wiesbaden ER - TY - JOUR A1 - Fischer, Jan-Thomas A1 - Kowalski, Julia A1 - Pudasaini, Shiva P. T1 - Topographic curvature effects in applied avalanche modelling JF - Cold Regions Science and Technology N2 - This paper describes the implementation of topographic curvature effects within the RApid Mass MovementS (RAMMS) snow avalanche simulation toolbox. RAMMS is based on a model similar to shallow water equations with a Coulomb friction relation and the velocity dependent Voellmy drag. It is used for snow avalanche risk assessment in Switzerland. The snow avalanche simulation relies on back calculation of observed avalanches. The calibration of the friction parameters depends on characteristics of the avalanche track. The topographic curvature terms are not yet included in the above mentioned classical model. Here, we fundamentally improve this model by mathematically and physically including the topographic curvature effects. By decomposing the velocity dependent friction into a topography dependent term that accounts for a curvature enhancement in the Coulomb friction, and a topography independent contribution similar to the classical Voellmy drag, we construct a general curvature dependent frictional resistance, and thus propose new extended model equations. With three site-specific examples, we compare the apparent frictional resistance of the new approach, which includes topographic curvature effects, to the classical one. Our simulation results demonstrate substantial effects of the curvature on the flow dynamics e.g., the dynamic pressure distribution along the slope. The comparison of resistance coefficients between the two models demonstrates that the physically based extension presents an improvement to the classical approach. Furthermore a practical example highlights its influence on the pressure outline in the run out zone of the avalanche. Snow avalanche dynamics modeling natural terrain curvature centrifugal force friction coefficients. KW - Snow KW - Avalanche Y1 - 2012 U6 - http://dx.doi.org/10.1016/j.coldregions.2012.01.005 SN - 1872-7441 VL - 74-75 SP - 21 EP - 30 PB - Elsevier CY - Amsterdam ER - TY - JOUR A1 - Weber, Tobias A1 - Arent, Jan-Christoph A1 - Steffen, Lucas A1 - Balvers, Johannes M. A1 - Duhovic, Miro T1 - Thermal optimization of composite autoclave molds using the shift factor approach for boundary condition estimation JF - Journal of Composite Materials Y1 - 2017 U6 - http://dx.doi.org/10.1177/0021998317699868 SN - 1530-793X VL - 51 IS - 12 SP - 1753 EP - 1767 PB - Sage CY - London ER - TY - JOUR A1 - Wild, Dominik A1 - Schrezenmeier, Johannes A1 - Czupalla, Markus A1 - Förstner, Markus T1 - Thermal Characterization of additive manufactured Integral Structures for Phase Change Applications JF - 2020 International Conference on Environmental Systems N2 - “Infused Thermal Solutions” (ITS) introduces a method for passive thermal control to stabilize structural components thermally without active heating and cooling systems, by using phase change material (PCM) in combination with lattice – both embedded into an additive manufactured integral structure. The technology is currently under development. This paper presents the results of the thermal property measurements performed on additive manufactured ITS breadboards. Within the breadboard campaigns key characteristics of the additive manufactured specimens were derived: Mechanical parameters: specimen impermeability, minimum wall thickness, lattice structure, subsequent heat treatment. Thermal properties: thermo-optical surface properties of the additive manufactured raw material, thermal conductivity and specific heat capacity measurements. As a conclusion the paper introduces an overview of potential ITS hardware applications, expected to increase the thermal performance. Y1 - 2020 PB - Texas Tech University ER - TY - JOUR A1 - Wittmann, Klaus A1 - Padeken, D. T1 - The User Center for Microgravity MUSC - Support for space experiments JF - DLR-Nachrichten. 70 (1993) Y1 - 1993 SN - 0937-0420 SP - 19 EP - 24 ER - TY - JOUR A1 - Blome, Hans-Joachim T1 - The scale of the universe: a unit of length JF - Comments on astrophysics. 17 (1994) Y1 - 1994 SN - 0146-2970 SP - 327 EP - 335 ER - TY - JOUR A1 - Wittmann, Klaus A1 - Bibring, J.-P. A1 - Rosenbauer, H. A1 - Boehnhardt, H. T1 - The Rosetta Lander (“Philae”) Investigations / Bibring, J.-P. ; Rosenbauer, H. ; Boehnhardt, H. ; [...] Wittmann, K. JF - Space Science Reviews. 128 (2007), H. 1-4 Y1 - 2007 SN - 0038-6308 SP - 205 EP - 220 ER - TY - JOUR A1 - Blome, Hans-Joachim A1 - Wilson, Thomas L. T1 - The quantum temperature of accelerating cosmological models of an entangled Universe JF - Advances in Space Research. 35 (2005), H. 1 Y1 - 2005 SN - 0273-1177 SP - 111 EP - 115 ER - TY - JOUR A1 - Blome, Hans-Joachim A1 - Priester, Wolfgang T1 - The problem of the primeval explosion: 'Big bang' or 'big bounce'? I JF - Sterne und Weltraum. 26 (1987) Y1 - 1987 SN - 0039-1263 SP - 83 EP - 89 ER -