TY - CHAP A1 - Weiss, Alexander A1 - Abanteriba, Sylvester A1 - Esch, Thomas T1 - Investigation of Flow Separation Inside a Conical Rocket Nozzle With the Aid of an Annular Cross Flow T2 - Proceedings of the ASME/JSME 2007 5th Joint Fluids Engineering Conference. Volume 1: Symposia, Parts A and B N2 - Flow separation is a phenomenon that occurs in all kinds of supersonic nozzles sometimes during run-up and shut-down operations. Especially in expansion nozzles of rocket engines with large area ratio, flow separation can trigger strong side loads that can damage the structure of the nozzle. The investigation presented in this paper seeks to establish measures that may be applied to alter the point of flow separation. In order to achieve this, a supersonic nozzle was placed at the exit plane of the conical nozzle. This resulted in the generation of cross flow surrounding the core jet flow from the conical nozzle. Due to the entrainment of the gas stream from the conical nozzle the pressure in its exit plane was found to be lower than that of the ambient. A Cold gas instead of hot combustion gases was used as the working fluid. A mathematical simulation of the concept was validated by experiment. Measurements confirmed the simulation results that due to the introduction of a second nozzle the pressure in the separated region of the conical nozzle was significantly reduced. It was also established that the boundary layer separation inside the conical nozzle was delayed thus allowing an increased degree of overexpansion. The condition established by the pressure measurements was also demonstrated qualitatively using transparent nozzle configurations. Y1 - 2007 SN - 0-7918-4288-6 U6 - http://dx.doi.org/10.1115/FEDSM2007-37387 N1 - Proceedings of the ASME/JSME 2007 5th Joint Fluids Engineering Conference. Volume 1: Symposia, Parts A and B. San Diego, California, USA. July 30–August 2, 2007 SP - 1861 EP - 1871 PB - American Society of Mechanical Engineers (ASME) CY - New York ER - TY - THES A1 - Weisbecker, Helen T1 - 550 nm : Farbwechsel von Tieren - Kommunikation in der Natur N2 - „550 nm“ befasst sich mit dem physiologischen Farbwechsel von Tieren. Einige Fische, Amphibien und Reptilien – wie beispielsweise das Chamäleon oder der Tintenfisch – können ihre Körperfarbe schnell wechseln. Unsere Natur leidet unter Kriegen und dem Klimawandel und verliert dadurch ihre Schönheit. Diese zeichnet sich vor allem durch die beachtliche Diversität der Körperfärbung von Tieren aus. Die Funktionen erstrecken sich über Tarnung, Auflauern oder Warnung bis hin zu einer Werbefärbung. Nicht nur Tiere nutzen Farbe als Ausdrucks- und Kommunikationsmittel. Auch Designer*innen bedienen sich an Farben, um Stimmungen zu vermitteln oder um Aufmerksamkeit und Individualität zu generieren. In „550 nm“ wird das Phänomen des Farbwechsels durch Illustrationen visualisiert und soll als Inspiration für Designinnovationen dienen. KW - Natur KW - Farbwechsel KW - Farbe KW - Tiere KW - Kommunikation Y1 - 2023 PB - FH Aachen CY - Aachen ER - TY - RPRT A1 - Weis, Fabian A1 - Schorn, Christian A1 - Anthrakidis, Anette A1 - Herrmann, Ulf T1 - Entwicklung eines kleinen Parabolrinnenkollektors mit Kunststoffkorpus zur Bereitstellung solarer Prozesswärme : Poly-P : Abschlussbericht Y1 - 2016 PB - Solar-Institut Jülich CY - Jülich ER - TY - CHAP A1 - Weingart, Daniel A1 - Schneider, Ulf A1 - Wollert, Jörg T1 - Doppelt gekoppelt - Kabellose und dynamische Anbindung von CANopen an Profinet IO T2 - Elektrische Automatisierung - Systeme und Komponenten: SPS-IPC-Drives 2009, Fachmesse & Kongress, 24. - 26. Nov. 2009, Nürnberg ; [Tagungsband] Y1 - 2009 SN - 978-3-8007-3184-8 SP - 147 EP - 154 PB - VDE-Verl. CY - Berlin [u.a.] ER - TY - CHAP A1 - Weil, M. A1 - Poghossian, Arshak A1 - Schöning, Michael Josef A1 - Cherstvy, A. T1 - Electrical monitoring of layer-by-layer adsorption of oppositely charged macromolecules by means of capacitive field-effect devices Y1 - 2012 SN - 978-3-9813484-2-2 U6 - http://dx.doi.org/10.5162/IMCS2012/P2.5.2 SP - 1575 EP - 1578 ER - TY - JOUR A1 - Weihe, Stefan A1 - Ernst, Ansgar A1 - Röth, Thilo A1 - Proksch, Johannes T1 - Aluminium-Stahl-Verbundguss im Nutzfahrzeugbau JF - ATZ - Automobiltechnische Zeitschrift N2 - In modernen Fahrzeugkarosserien der Großserie kommen zunehmend Materialmischbauweisen zur Anwendung. In Zusammenarbeit der Daimler AG, der Tower Automotive Holding GmbH, der Imperia GmbH sowie der Partnerunternehmen KSM Castings GmbH und Schaufler Tooling GmbH & Co. KG wird das Leichtbaupotenzial von Aluminiumverbundguss-Stahlblech-Hybriden am Beispiel des vorderen Dachquerträgers des Mercedes-Benz Viano/Vito ausführlich untersucht. Y1 - 2013 SN - 2192-8800 (Online) SN - 0001-2785 (Print) VL - 115 IS - 4 SP - 312 EP - 316 PB - Springer Fachmedien Wiesbaden ER - TY - JOUR A1 - Weihe, Stefan A1 - Ansgar, Ernst A1 - Röth, Thilo A1 - Proksch, Johannes T1 - Leichtmetall-Stahl-Verbundguss im Nutzfahrzeugbau JF - Lightweight Design N2 - In modernen Fahrzeugkarosserien der Großserie kommen zunehmend Materialmischbauweisen zur Anwendung. In Zusammenarbeit der Daimler AG, der Tower Automotive Holding GmbH, der Imperia GmbH sowie der Partnerunternehmen KSM Castings GmbH und Schaufler Tooling GmbH & Co. KG wird das Leichtbaupotenzial von Stahlblech-AluminiumverbundgussHybriden am Beispiel des vorderen Dachquerträgers des Mercedes-Benz Viano/Vito ausführlich untersucht. Y1 - 2013 SN - 2192-8738 (Online) SN - 1865-4819 (Print) VL - 6 IS - 2 SP - 38 EP - 43 PB - Springer CY - Berlin ER - TY - JOUR A1 - Weigand, Christoph A1 - Collani, E. v. A1 - Saniga, E.M. T1 - Economic Adjustment Design for -Control Charts. E.v.Collani, E.M. Saniga, Ch. Weigand JF - IIE Transactions / Institute of Industrial Engineers. 26 (1994), H. 6 Y1 - 1994 SN - 0569-5554 ER - TY - JOUR A1 - Weigand, Christoph T1 - Optimal Production Schedule for a K Products Single Machine Problem JF - Economic Quality Control. 9 (1994) Y1 - 1994 SN - 0940-5151 SP - 91 EP - 101 ER - TY - JOUR A1 - Weigand, Christoph T1 - Optimale Maschinenjustierung JF - Technische Hochschule / Bibliothek: Wissenschaftliche Zeitschrift. 37 (1991) Y1 - 1991 SN - 0043-6917 SP - 167 EP - 175 ER - TY - JOUR A1 - Weigand, Christoph T1 - A Solution to the Scheduling Problem Taking into Account Quality JF - Operations research '91 : extended abstracts of the 16th Symposium on Operations Research held at the University of Trier at September 9 - 11, 1991 / [GMÖOR]. Peter Gritzmann ... (eds.) Y1 - 1991 SN - 3790806080 N1 - Symposium on Operations Research ; (16, 1991, Trier) SP - 373 EP - 375 PB - Physica-Verl. CY - Heidelberg ER - TY - JOUR A1 - Weigand, Christoph T1 - Optimal Adjustment Policies JF - Proceedings of the First Umeå-Würzburg Conference in Statistics : Kronlund Conference Center and University of Umeå, September 10 - 14, 1990 / ed. by Kurt Brännäs Y1 - 1990 SN - 91-7174-564-5 N1 - Umeå-Würzburg Conference in Statistics <1, 1990> SP - 147 EP - 158 PB - Univ. of Umeå CY - Umeå ER - TY - BOOK A1 - Weigand, Christoph T1 - Statistik mit und ohne Zufall : eine anwendungsorientierte Einführung ; mit 10 Tabellen / Christoph Weigand Y1 - 2006 SN - 3-7908-1693-0 N1 - [Neuere Aufl. vorh.] https://doi.org/10.1007/978-3-662-59309-7 PB - Physica-Verl. CY - Heidelberg ER - TY - JOUR A1 - Weigand, Christoph T1 - Technically Optimal Inspection Policy with Arithmetical Adaption JF - IMA Journal of Management Mathematics. 14 (2003), H. 4 Y1 - 2003 SN - 1471-678X N1 - weitere ISSN 1471-6798 (E) SP - 357 EP - 371 ER - TY - JOUR A1 - Weigand, Christoph T1 - Economically Optimal Inspection Policy with Geometrical Adaption JF - Journal of Applied Statistics. 30 (2003), H. 5 Y1 - 2003 SN - 0266-4763 N1 - weitere ISSN 1360-0532 (E) SP - 555 EP - 569 ER - TY - JOUR A1 - Weigand, Christoph T1 - Economically Optimal Inspection Policy with Arithmetical Adaption JF - Applied stochastic models and data analysis / [10th International Symposium on Applied Stochastic Models and Analysis, June 12-15 2001, Université Technologique de Compiègne] ; editors Gérard Govaert, Jacques Janssen, Nikolaos Limnios. Y1 - 2001 N1 - ASDMA 2001 SP - 1010 EP - 1015 PB - Université Technologique de Compiègne CY - Compiègne ER - TY - JOUR A1 - Weigand, Christoph T1 - Economically Optimal Adaptive Inspection Policies JF - Economic Quality Control. 15 (2000), H. 1/2 Y1 - 2000 SN - 0940-5151 N1 - Printausgabe vorhanden: 43 Z 711 SP - 55 EP - 77 ER - TY - JOUR A1 - Weigand, Christoph T1 - Economic Machine Adjustment in the Case of Product Screening .E.v.Collani, Ch. Weigand JF - Statistical Papers. 33 (1992) Y1 - 1992 SP - 171 EP - 184 ER - TY - JOUR A1 - Weigand, Christoph T1 - On the Effects of SPC on Production Time JF - Economic Quality Control. 8 (1993) Y1 - 1993 SN - 0940-5151 SP - 23 EP - 61 ER - TY - JOUR A1 - Weigand, Christoph T1 - A new Approach for Optimal Control of a Production process JF - Economic Quality Control. 7 (1992) Y1 - 1992 SN - 0940-5151 SP - 225 EP - 251 ER -