TY - JOUR A1 - Anik, Sabri A1 - Frohberg, Martin G. A1 - Kapoor, Madan Lal T1 - Prediction of thermodynamic properties of oxygen in binary metallic solvents JF - Zeitschrift für Metallkunde Y1 - 1983 SN - 0044-3093 VL - 74 IS - 6 SP - 372 EP - 375 ER - TY - JOUR A1 - Schöning, Michael Josef A1 - Doll, Theodor A1 - Wagner, Patrick T1 - Preface / Doll, Theodor ; Wagner, Patrick ; Schöning, Michael J. JF - physica status solidi (a) . 206 (2009), H. 3 Y1 - 2009 SN - 1862-6319 N1 - Special Issue: Engineering of Functional Interfaces (EnFI 08) SP - 389 EP - 390 ER - TY - JOUR A1 - Kezerashvili, Roman Ya A1 - Dachwald, Bernd T1 - Preface: Solar sailing: Concepts, technology, and missions II JF - Advances in Space Research Y1 - 2021 U6 - https://doi.org/10.1016/j.asr.2021.01.037 SN - 0273-1177 VL - 67 IS - 9 SP - 2559 EP - 2560 PB - Elsevier CY - Amsterdam ER - TY - JOUR A1 - Biener, Ernst A1 - Sasse, T. A1 - Bökers, H. T1 - Preliminary or final capping of sanitary landfills? : Technical and economical aspects JF - Sardinia 99 : proceedings / Seventh International Waste Management and Landfill Symposium, [4 - 8 October 1999, S. Margherita di Pula, Cagliari, Sardinia, Italy]. Ed.: Thomas H. Christensen. - Bd. 3 : Barriers, waste mechanics and landfill design Y1 - 1999 N1 - International Waste Management and Landfill Symposium <7, 1999, Cagliari> SP - 287 EP - 294 PB - CISA, Environmental Sanitary Engineering Centre CY - Cagliari ER - TY - JOUR A1 - Khodaverdi, M. A1 - Pauly, F. A1 - Schroder, G. A1 - Ziemons, Karl A1 - Sievering, R. A1 - Halling, H. T1 - Preliminary studies of a micro-CT for a combined small animal PET/CT scanner JF - 2001 IEEE Nuclear Science Symposium Conference Record, Vol. 3 N2 - We are developing an X-ray computed tomography (CT) system which will be combined with a high resolution animal PET system. This permits acquisition of both molecular and anatomical images in a single machine. In particular the CT will also be utilized for the quantification of the animal PET data by providing accurate data for attenuation correction. A first prototype has been built using a commercially available plane silicon diode detector. A cone-beam reconstruction provides the images using the Feldkamp algorithm. First measurements with this system have been performed on a mouse. It could be shown that the CT setup fulfils all demands for a high quality image of the skeleton of the mouse. It is also suited for soft tissue measurements. To improve contrast and resolution and to acquire the X-ray energy further development of the system, especially the use of semiconductor detectors and iterative reconstruction algorithms are planned. Y1 - 2002 SN - 1082-3654 SP - 1605 EP - 1606 ER - TY - JOUR A1 - Biselli, Manfred A1 - Schmid, Georg A1 - Wandrey, Christian T1 - Preparation of cellodextrins and isolation of oligomeric side components and their characterization / Schmid, Georg ; Biselli, Manfred ; Wandrey, Christian JF - Analytical Biochemistry. 175 (1988) Y1 - 1988 SN - 0003-2697 SP - 573 EP - 583 ER - TY - JOUR A1 - Biener, Ernst A1 - Sasse, T. A1 - Konertz, K. T1 - Preparation of mineral sealing materials for landfills by different processing technologies / Sasse, T. ; Biener, E. ; Konertz, K. JF - Sardinia 93 : Fourth International Landfill Symposium "Barrier systems, environmental aspects, upgrading and remediation, siting, monofills, effects of waste pretreatment, landfilling in developing countries" ; 11 - 15 October 1993, S. Margherita di Pula (Cagliari), Sardinia, Italy ; proceedings / coord. by Thomas H. Christensen ... - Bd. 1 Y1 - 1993 N1 - International Landfill Symposium <4, 1993, Santa Margherita, Pula> SP - 275 EP - 283 PB - CISA, Environmental Sanitary Engineering Centre CY - Cagliari ER - TY - JOUR A1 - Förster, Arnold A1 - Cambel, V. A1 - Kicin, S. A1 - Kuliffayová, M. T1 - Preparation of patterned GaAs structures for MEMS and MOEMS. Cambel, V.; Kicin, S.; Kuliffayová, M.; Kovácová, E.; Novák, J.; Kostic, I.; Förster, A. JF - Materials Science and Engineering: C. 19 (2002), H. 2 Y1 - 2002 SN - 0928-4931 SP - 161 EP - 165 ER - TY - JOUR A1 - Kotter, Michael A1 - Hammon, U. T1 - Preparation of pellets with well-defined pore structure / U. Hammon ; A. Kotter JF - International chemical engineering. 26 (1986), H. 4 Y1 - 1986 SN - 0020-6318 SP - 563 EP - 573 ER - TY - JOUR A1 - Naithani, V. K A1 - Klostermeyer, Henning A1 - Lange, H. R. A1 - [u.a.], A1 - Berndt, Heinz A1 - [u.a.], T1 - Preparation of peptide derivatives for porcine proinsulin-synthesis JF - Biological Chemistry Y1 - 1971 U6 - https://doi.org/10.1515/bchm2.1971.352.1.1 SN - 1437-4315 VL - 352 IS - 1 SP - 2 EP - 3 PB - De Gruyter ER - TY - JOUR A1 - Gossla, Ulrich A1 - Sato, R. T1 - Present production circumstances of aggregate in Germany / Sato, R.; Gossla, U. JF - Cement & Concrete (1998) Y1 - 1998 N1 - auf Japanisch SP - 146 EP - 153 ER - TY - JOUR A1 - Prielmeier, Franz A1 - Woznyj, M. A1 - Lüdemann, H.-D. T1 - Pressure Dependence of the Melting and Self Diffusion in 2,2-Dimethylpropane, 2,2-Dimethylpropionitrile, and 2-Methylpropanol-2 / M. Woznyj, F. X. Prielmeier, H.-D. Lüdemann JF - Zeitschrift für Naturforschung A, Journal of Physical Sciences. 39 (1984) Y1 - 1984 SN - 0932-0784 SP - 800 ER - TY - JOUR A1 - Prielmeier, Franz A1 - Lang, E. W. A1 - Lüdemann, H.-D. T1 - Pressure dependence of the self-diffusion in liquid trifluoromethane / F. X. Prielmeier; E. W. Lang; H.-D. Lüdemann JF - Molecular Physics. 52 (1984), H. 5 Y1 - 1984 SN - 0026-8976 SP - 1105 EP - 1113 ER - TY - JOUR A1 - Rausch, Valentin A1 - Kahmann, Stephanie Lucina A1 - Baltschun, Christoph A1 - Staat, Manfred A1 - Müller, Lars P. A1 - Wegmann, Kilian T1 - Pressure distribution to the distal biceps tendon at the radial tuberosity: a biomechanical study JF - The Journal of Hand Surgery N2 - Purpose Mechanical impingement at the narrow radioulnar space of the tuberosity is believed to be an etiological factor in the injury of the distal biceps tendon. The aim of the study was to compare the pressure distribution at the proximal radioulnar space between 2 fixation techniques and the intact state. Methods Six right arms and 6 left arms from 5 female and 6 male frozen specimens were used for this study. A pressure transducer was introduced at the height of the radial tuberosity with the intact distal biceps tendon and after 2 fixation methods: the suture-anchor and the cortical button technique. The force (N), maximum pressure (kPa) applied to the radial tuberosity, and the contact area (mm²) of the radial tuberosity with the ulna were measured and differences from the intact tendon were detected from 60° supination to 60° pronation in 15° increments with the elbow in full extension and in 45° and 90° flexion of the elbow. Results With the distal biceps tendon intact, the pressures during pronation were similar regardless of extension and flexion and were the highest at 60° pronation with 90° elbow flexion (23.3 ± 53.5 kPa). After repair of the tendon, the mean peak pressure, contact area, and total force showed an increase regardless of the fixation technique. Highest peak pressures were found using the cortical button technique at 45° flexion of the elbow and 60° pronation. These differences were significantly different from the intact tendon. The contact area was significantly larger in full extension and 15°, 30°, and 60° pronation using the cortical button technique. Conclusions Pressures on the distal biceps tendon at the radial tuberosity increase during pronation, especially after repair of the tendon. Clinical relevance Mechanical impingement could play a role in both the etiology of primary distal biceps tendon ruptures and the complications occurring after fixation of the tendon using certain techniques. Y1 - 2020 U6 - https://doi.org/10.1016/j.jhsa.2020.01.006 SN - 0363-5023 VL - 45 IS - 8 SP - 776.e1 EP - 776.e9 PB - Elsevier CY - Amsterdam ER - TY - JOUR A1 - Digel, Ilya T1 - Primary thermosensory events in cells JF - Transient receptor potential channels / Md. Shahidul Islam, ed. Y1 - 2011 SN - 978-94-007-0264-6 N1 - (Advances in experimental medicine and biology ; 704) SP - 451 EP - 468 PB - Springer CY - Dordrecht [u.a.] ER - TY - JOUR A1 - Matcha, Heike A1 - Ljubas, Ante A1 - Gueldemet, Harun ED - Kepczynska-Walczak, A. T1 - Printing a Coffee Bar: An investigation into mid-scale 3D printing JF - Computing for a better tomorrow - Proceedings of the 36th eCAADe Conference - Volume 2, Lodz University of Technology, Lodz, Poland, 19-21 September 2018 N2 - We present and discuss an exploration of the possibilities and properties of 3D printing with a printing space of 1 cubic meter, and how those can be integrated into architectural education through an experimental design and research course with students of architecture.We expand on issues presented at the eCAADe conference 2017 in Rome [Ref 6] by increasing the complexity and size of our prints, printing not a model to scale, but a full scale funtional prototype of a usable architectural object: A coffee bar. Y1 - 2018 SP - 59 EP - 68 ER - TY - JOUR A1 - Thoma, Andreas A1 - Thomessen, Karolin A1 - Gardi, Alessandro A1 - Fisher, A. A1 - Braun, Carsten T1 - Prioritising paths: An improved cost function for local path planning for UAV in medical applications JF - The Aeronautical Journal N2 - Even the shortest flight through unknown, cluttered environments requires reliable local path planning algorithms to avoid unforeseen obstacles. The algorithm must evaluate alternative flight paths and identify the best path if an obstacle blocks its way. Commonly, weighted sums are used here. This work shows that weighted Chebyshev distances and factorial achievement scalarising functions are suitable alternatives to weighted sums if combined with the 3DVFH* local path planning algorithm. Both methods considerably reduce the failure probability of simulated flights in various environments. The standard 3DVFH* uses a weighted sum and has a failure probability of 50% in the test environments. A factorial achievement scalarising function, which minimises the worst combination of two out of four objective functions, reaches a failure probability of 26%; A weighted Chebyshev distance, which optimises the worst objective, has a failure probability of 30%. These results show promise for further enhancements and to support broader applicability. KW - Path planning KW - Cost function KW - Multi-objective optimization Y1 - 2023 U6 - https://doi.org/10.1017/aer.2023.68 SN - 0001-9240 (Print) SN - 2059-6464 (Online) IS - First View SP - 1 EP - 18 PB - Cambridge University Press CY - Cambridge ER - TY - JOUR A1 - Staat, Manfred T1 - Probabilistic assessment of the fracture mechanics behaviour of an HTR-module primary circuit pressure boundary JF - Nuclear Engineering and Design. 160 (1996), H. 1-2 Y1 - 1996 SN - 0029-5493 SP - 221 EP - 236 ER - TY - JOUR A1 - Tran, Thanh Ngoc A1 - Kreißig, R. A1 - Staat, Manfred T1 - Probabilistic limit and shakedown analysis of thin plates and shells JF - Structural safety. 31 (2009), H. 1 Y1 - 2009 SN - 0167-4730 SP - 1 EP - 18 PB - - ER - TY - JOUR A1 - Staat, Manfred A1 - Heitzer, M. T1 - Probabilistic limit and shakedown problems JF - Numerical Methods for Limit and Shakedown Analysis. Deterministic and Probabilistic Approach. NIC Series Vol. 15 / Ed. by Staat, M; Heitzer, M. Y1 - 2003 SN - 3-00-010001-6 SP - 217 EP - 268 PB - John von Neumann Institute for Computing (NIC) CY - Jülich ER -