Article
Refine
Year of publication
Institute
- ECSM European Center for Sustainable Mobility (32) (remove)
Language
- English (32) (remove)
Document Type
- Article (32) (remove)
Keywords
- Brake set-up (2)
- Freight rail (2)
- Obstacle avoidance (2)
- Path planning (2)
- UAV (2)
- Active humidity control (1)
- Aircraft sizing (1)
- Automotive safety approach (1)
- Autonomy (1)
- Bio-inspired systems (1)
- Brake test (1)
- Braking curves (1)
- CFD (1)
- CO2 emission reduction targets (1)
- Centrifugal twisting moment (1)
- Commercial Vehicle (1)
- Common Rail Injection System (1)
- Cost function (1)
- Crashworthiness (1)
- Diesel Engine (1)
- Driver assistance system (1)
- Driving cycle recognition (1)
- Dynamic simulation (1)
- ECMS (1)
- Electrochemical impedance spectroscopy (1)
- Energy management strategies (1)
- European Transient Cycle (1)
- Extension–twist coupling (1)
- Full-vehicle crash test (1)
- Human factors (1)
- Impedance analysis (1)
- Incident analysis (1)
- Lifting propeller (1)
- Local path planning (1)
- Molten salt receiver system (1)
- Molten salt solar tower (1)
- Multi-objective optimization (1)
- PEM fuel cell (1)
- Parasitic drag (1)
- Predictive battery discharge (1)
- Relative air humidity (1)
- Selective Catalytic Reduction (1)
- Shunting (1)
- Train composition (1)
- Transient flux distribution (1)
- Trapeze effect (1)
- Two-phase modelling (1)
- Unmanned aerial vehicles (1)
- adaptive systems (1)
- artificial intelligence (1)
- assistance system (1)
- eVTOL development (1)
- eVTOL safety (1)
- fuel cell vehicle (1)
- gamification (1)
- intelligent control (1)
- intelligent energy management (1)
- machine learning (1)
- manufacturing (1)
- optimization system (1)
Lifting propellers are of increasing interest for Advanced Air Mobility. All propellers and rotors are initially twisted beams, showing significant extension–twist coupling and centrifugal twisting. Torsional deformations severely impact aerodynamic performance. This paper presents a novel approach to assess different reasons for torsional deformations. A reduced-order model runs large parameter sweeps with algebraic formulations and numerical solution procedures. Generic beams represent three different propeller types for General Aviation, Commercial Aviation, and Advanced Air Mobility. Simulations include solid and hollow cross-sections made of aluminum, steel, and carbon fiber-reinforced polymer. The investigation shows that centrifugal twisting moments depend on both the elastic and initial twist. The determination of the centrifugal twisting moment solely based on the initial twist suffers from errors exceeding 5% in some cases. The nonlinear parts of the torsional rigidity do not significantly impact the overall torsional rigidity for the investigated propeller types. The extension–twist coupling related to the initial and elastic twist in combination with tension forces significantly impacts the net cross-sectional torsional loads. While the increase in torsional stiffness due to initial twist contributes to the overall stiffness for General and Commercial Aviation propellers, its contribution to the lift propeller’s stiffness is limited. The paper closes with the presentation of approximations for each effect identified as significant. Numerical evaluations are necessary to determine each effect for inhomogeneous cross-sections made of anisotropic material.