Refine
Year of publication
- 2024 (59) (remove)
Document Type
- Article (16)
- Bachelor Thesis (16)
- Part of a Book (13)
- Conference Proceeding (6)
- Book (5)
- Patent (1)
- Preprint (1)
- Working Paper (1)
Keywords
- Digitalisierung (2)
- Dokumentarfilm (2)
- Fashion (2)
- Hot S-parameter (2)
- Kultur (2)
- Magazin (2)
- 1P hub loads (1)
- 3-D printing (1)
- 3D (1)
- Acyl-amino acids (1)
- Acylation (1)
- Aeroelasticity (1)
- Ageing (1)
- Aminoacylase (1)
- Anatomy (1)
- Animation (1)
- Anomalieerkennung (1)
- Anti-Obdachlosen Architektur (1)
- Arztpraxis (1)
- Avatar-Anprobe (1)
Institute
- Fachbereich Gestaltung (16)
- Fachbereich Medizintechnik und Technomathematik (15)
- Fachbereich Bauingenieurwesen (13)
- IfB - Institut für Bioengineering (7)
- Fachbereich Elektrotechnik und Informationstechnik (5)
- INB - Institut für Nano- und Biotechnologien (5)
- ECSM European Center for Sustainable Mobility (2)
- Fachbereich Chemie und Biotechnologie (2)
- Fachbereich Luft- und Raumfahrttechnik (2)
- Fachbereich Wirtschaftswissenschaften (2)
- Fachbereich Architektur (1)
- IBB - Institut für Baustoffe und Baukonstruktionen (1)
- Institut fuer Angewandte Polymerchemie (1)
A novel method to determine the extruded length of a metallic wire for a directed energy deposition (DED) process using a microwave (MW) plasma jet with a straight-through wire feed is presented. The method is based on the relative comparison of the measured frequency response obtained by the large-signal scattering parameter (Hot-S) technique. In the practical working range, repeatability of less than 6% for a nonactive plasma and 9% for the active plasma state is found. Measurements are conducted with a focus on a simple solution to decrease the processing time and reduce the integration time of the process into the existing hardware. It is shown that monitoring a single frequency for magnitude and phase changes is sufficient to achieve good accuracy. A combination of different measurement values to determine the length is possible. The applicability to different diameter of the same material is shown as well as a contact detection of the wire and metallic substrate.