Refine
Year of publication
- 2024 (127) (remove)
Institute
- Fachbereich Gestaltung (45)
- Fachbereich Medizintechnik und Technomathematik (23)
- Fachbereich Bauingenieurwesen (14)
- Fachbereich Elektrotechnik und Informationstechnik (14)
- Fachbereich Wirtschaftswissenschaften (11)
- IfB - Institut für Bioengineering (10)
- Fachbereich Luft- und Raumfahrttechnik (8)
- INB - Institut für Nano- und Biotechnologien (7)
- Fachbereich Chemie und Biotechnologie (6)
- ECSM European Center for Sustainable Mobility (5)
Document Type
- Bachelor Thesis (46)
- Article (39)
- Part of a Book (17)
- Conference Proceeding (11)
- Working Paper (6)
- Book (5)
- Preprint (2)
- Patent (1)
Keywords
- Nachhaltigkeit (4)
- Fotografie (3)
- Kultur (3)
- Deutschland (2)
- Digitalisierung (2)
- Dokumentarfilm (2)
- Engineering education (2)
- Fashion (2)
- Hot S-parameter (2)
- Illustration (2)
Zugriffsart
- weltweit (47)
- campus (33)
- bezahl (14)
- fachbereichsweit (FB4) (9)
A novel method to determine the extruded length of a metallic wire for a directed energy deposition (DED) process using a microwave (MW) plasma jet with a straight-through wire feed is presented. The method is based on the relative comparison of the measured frequency response obtained by the large-signal scattering parameter (Hot-S) technique. In the practical working range, repeatability of less than 6% for a nonactive plasma and 9% for the active plasma state is found. Measurements are conducted with a focus on a simple solution to decrease the processing time and reduce the integration time of the process into the existing hardware. It is shown that monitoring a single frequency for magnitude and phase changes is sufficient to achieve good accuracy. A combination of different measurement values to determine the length is possible. The applicability to different diameter of the same material is shown as well as a contact detection of the wire and metallic substrate.