Refine
Year of publication
- 2020 (157) (remove)
Document Type
- Article (93)
- Conference Proceeding (46)
- Part of a Book (13)
- Book (2)
- Doctoral Thesis (2)
- Poster (1)
Language
- English (157) (remove)
Keywords
- MINLP (3)
- Additive manufacturing (2)
- Adjacent buildings (2)
- Experimental validation (2)
- Historical centres (2)
- Shake table test (2)
- Stone masonry (2)
- 3D printing (1)
- Acceptance (1)
- Adaptive control (1)
- Biofuel (1)
- Biorefinery (1)
- Blind prediction competition (1)
- Brownian Pillow (1)
- Bumblebees (1)
- Butanol (1)
- Capacity Building Higher Education (1)
- Capacity Curve (1)
- Case study (1)
- Change culture (1)
Institute
- Fachbereich Medizintechnik und Technomathematik (50)
- IfB - Institut für Bioengineering (33)
- Fachbereich Luft- und Raumfahrttechnik (28)
- Fachbereich Energietechnik (24)
- Fachbereich Elektrotechnik und Informationstechnik (20)
- ECSM European Center for Sustainable Mobility (13)
- Fachbereich Maschinenbau und Mechatronik (11)
- INB - Institut für Nano- und Biotechnologien (11)
- Fachbereich Chemie und Biotechnologie (10)
- Fachbereich Bauingenieurwesen (7)
- Fachbereich Wirtschaftswissenschaften (7)
- Solar-Institut Jülich (7)
- MASKOR Institut für Mobile Autonome Systeme und Kognitive Robotik (5)
- Nowum-Energy (5)
- Institut fuer Angewandte Polymerchemie (4)
- IaAM - Institut für angewandte Automation und Mechatronik (1)
- Kommission für Forschung und Entwicklung (1)
- ZHQ - Bereich Hochschuldidaktik und Evaluation (1)
This paper analyzes the drag characteristics of several landing gear and turret configurations that are representative of unmanned aircraft tricycle landing gears and sensor turrets. A variety of these components were constructed via 3D-printing and analyzed in a wind-tunnel measurement campaign. Both turrets and landing gears were attached to a modular fuselage that supported both isolated components and multiple components at a time. Selected cases were numerically investigated with a Reynolds-averaged Navier-Stokes approach that showed good accuracy when compared to wind-tunnel data. The drag of main gear struts could be significantly reduced via streamlining their cross-sectional shape and keeping load carrying capabilities similar. The attachment of wheels introduced interference effects that increased strut drag moderately but significantly increased wheel drag compared to isolated cases. Very similar behavior was identified for front landing gears. The drag of an electro-optical and infrared sensor turret was found to be much higher than compared to available data of a clean hemisphere-cylinder combination. This turret drag was merely influenced by geometrical features like sensor surfaces and the rotational mechanism. The new data of this study is used to develop simple drag estimation recommendations for main and front landing gear struts and wheels as well as sensor turrets. These recommendations take geometrical considerations and interference effects into account.