Refine
Year of publication
- 2024 (44) (remove)
Institute
- Fachbereich Medizintechnik und Technomathematik (18)
- Fachbereich Elektrotechnik und Informationstechnik (7)
- Fachbereich Luft- und Raumfahrttechnik (7)
- INB - Institut für Nano- und Biotechnologien (7)
- IfB - Institut für Bioengineering (7)
- Fachbereich Chemie und Biotechnologie (5)
- ECSM European Center for Sustainable Mobility (4)
- Fachbereich Wirtschaftswissenschaften (3)
- Nowum-Energy (2)
- Arbeitsstelle fuer Hochschuldidaktik und Studienberatung (1)
Language
- English (44) (remove)
Document Type
- Article (29)
- Conference Proceeding (9)
- Book (2)
- Preprint (2)
- Part of a Book (1)
- Working Paper (1)
Keywords
- Engineering education (2)
- Hot S-parameter (2)
- 1P hub loads (1)
- 3-D printing (1)
- ABE (1)
- Accuracy (1)
- Acid crash (1)
- Active humidity control (1)
- Acyl-amino acids (1)
- Acylation (1)
A novel method to determine the extruded length of a metallic wire for a directed energy deposition (DED) process using a microwave (MW) plasma jet with a straight-through wire feed is presented. The method is based on the relative comparison of the measured frequency response obtained by the large-signal scattering parameter (Hot-S) technique. In the practical working range, repeatability of less than 6% for a nonactive plasma and 9% for the active plasma state is found. Measurements are conducted with a focus on a simple solution to decrease the processing time and reduce the integration time of the process into the existing hardware. It is shown that monitoring a single frequency for magnitude and phase changes is sufficient to achieve good accuracy. A combination of different measurement values to determine the length is possible. The applicability to different diameter of the same material is shown as well as a contact detection of the wire and metallic substrate.