Refine
Year of publication
- 2002 (250) (remove)
Institute
- Fachbereich Medizintechnik und Technomathematik (55)
- Fachbereich Energietechnik (33)
- Fachbereich Elektrotechnik und Informationstechnik (29)
- Fachbereich Wirtschaftswissenschaften (29)
- Fachbereich Luft- und Raumfahrttechnik (23)
- Fachbereich Maschinenbau und Mechatronik (22)
- Fachbereich Chemie und Biotechnologie (19)
- INB - Institut für Nano- und Biotechnologien (18)
- IfB - Institut für Bioengineering (13)
- Solar-Institut Jülich (10)
Document Type
- Article (167)
- Conference Proceeding (34)
- Book (32)
- Part of a Periodical (5)
- Part of a Book (3)
- Patent (3)
- Diploma Thesis (2)
- Report (2)
- Doctoral Thesis (1)
- Review (1)
Keywords
- Aachen University of Applied Sciences (5)
- Fachhochschule Aachen (5)
- Blitzschutz (3)
- Erneuerbare Energien (2)
- Lightning protection (2)
- Auto (1)
- Biomedizinische Technik (1)
- Bruchmechanik (1)
- CAD (1)
- CAD ; (1)
Macroporous silicon has been etched from n-type Si, using a vertical etching cell where no rear side contact on the silicon wafer is necessary. The resulting macropores have been characterised by means of Scanning Electron Microscopy (SEM). After etching, SiO₂ was thermally grown on the top of the porous silicon as an insulating layer and Si₃N₄ was deposited by means of Low Pressure Chemical Vapour Deposition (LPCVD) as transducer material to fabricate a capacitive pH sensor. In order to prepare porous biosensors, the enzyme penicillinase has been additionally immobilised inside the porous structure. Electrochemical measurements of the pH sensor and the biosensor with an Electrolyte/Insulator/Semiconductor (EIS) structure have been performed in the Capacitance/Voltage (C/V) and Constant capacitance (ConCap) mode.
Rezension zu: K. Zimmermann, Technische Mechanik – multimedial. Fachbuch Verlag Leipzig (2000)
(2002)
Structural design analyses are conducted with the aim of verifying the exclusion of ratcheting. To this end it is important to make a clear distinction between the shakedown range and the ratcheting range. In cyclic plasticity more sophisticated hardening models have been suggested in order to model the strain evolution observed in ratcheting experiments. The hardening models used in shakedown analysis are comparatively simple. It is shown that shakedown analysis can make quite stable predictions of admissible load ranges despite the simplicity of the underlying hardening models. A linear and a nonlinear kinematic hardening model of two-surface plasticity are compared in material shakedown analysis. Both give identical or similar shakedown ranges. Structural shakedown analyses show that the loading may have a more pronounced effect than the hardening model.
A small PET system has been built up with two multichannel photomultipliers, which are attached to a matrix of 64 single LSO crystals each. The signal from each multiplier is being sampled continuously by a 12 bit ADC at a sampling frequency of 40 MHz. In case of a scintillation pulse a subsequent FPGA sends the corresponding set of samples together with the channel information and a time mark to the host computer. The data transfer is performed with a rate of 20 MB/s. On the host all necessary information is extracted from the data. The pulse energy is determined, coincident events are detected and multiple hits within one matrix can be identified. In order to achieve a narrow time window the pulse starting time is refined further than the resolution of the time mark (=25 ns) would allow. This is possible by interpolating between the pulse samples. First data obtained from this system will be presented. The system is part of developments for a much larger system and has been created to study the feasibility and performance of the technique and the hardware architecture.
Coincident events in two scintillator crystals coupled to photomultipliers (PMT) are detected by processing just the digital data of the recorded pulses. For this purpose the signals from both PMTs are continuously sampled by free-running ADCs at a sampling rate of 40 MHz. For each sampled pulse the starting time is determined by processing the pulse data. Even a fairly simple interpolating algorithm results in a FWHM of about 2 ns.
Within the developments for the Crystal Clear small animal PET project (CLEARPET) a dual head PET system has been established. The basic principle is the early digitization of the detector pulses by free running ADCs. The determination of the γ-energy and also the coincidence detection is performed by data processing of the sampled pulses on the host computer. Therefore a time mark is attached to each pulse identifying the current cycle of the 40 MHz sampling clock. In order to refine the time resolution the pulse starting time is interpolated from the samples of the pulse rise. The detector heads consist of multichannel PMTs with a single LSO scintillator crystal coupled to each channel. For each PMT only one ADC is required. The position of an event is obtained separately from trigger signals generated for each single channel. An FPGA is utilized for pulse buffering, generation of the time mark and for the data transfer to the host via a fast I/O-interface.
Anmerkung zu BGH VII ZR 135/00 (Widerklage gegen einen am Rechtsstreit nicht beteiligten Dritten)
(2002)
Unbefristete Widerspruchsmöglichkeit des Schuldners im Einzugsermächtigungslastschriftverfahren
(2002)
In IEC 61312-2 equations for the assessment of the magnetic fields inside structures due to a direct lightning strike are given. These equations are based on computer simulations for shields consisting of a single-layer steel grid of a given mesh width. Real constructions, however, contain at least two layers of reinforcement steel grids. The objective of this study was to experimentally determine the additional shielding effectiveness of a second reinforcement layer compared to a single-layer grid. To this end, simulated structures were set up in the high current laboratory. The structures consisted of cubic cages of 2 m side length with one or with two reinforcement grids, respectively. The structures were exposed to direct lightning currents representing the variety of anticipated lightning current waveforms. The magnetic fields and their derivatives at several positions inside the structure as well as the voltage between “floor” and “roof” in the center were determined for different current injection points. From these data the improvement of the shielding caused by a second reinforcement layer is derived.
Das neue Tor zur Welt - Fachhochschule Aachen erhält ein Internet-Portal Studierende der Fachhochschule belegen die ersten Plätze beim Euregionalen Architektur-Preis 2001 Chancen im Maschinenbau Menschen aus der FH - Fatoumata Bezanger erste afrikanische Absolventin im Fachbereich Maschinenbau und Mechatronik Ehemalige gesucht! Erster Preis für Design-Studierende Exkursion in die Raumfahrtzentren der USA Auslands-Erfahrungen sind wichtig. 20 Jahre internationales Wirtschaftsstudium Neueste Erkenntnisse aus der Blitzforschung vorgestellt: Adam-Herbert-Preis verliehen Personal-Info Unsere Partnerhochhsculen vorgestellt: Die Technische Hochschule Nishnij Nowgorod Cisco-Akademie am FB 5 bietet begehrte Zusatzqualifikation für Informatiker Neue Gastprofessoren für Jülich Der Transistor als Bachbett Schwerelos in Südfrankreich 70. Geburtstag des Gründungsrektors Berufsausbildung an der Fachhochschule - Frauenförderung in Männerdomänen Euro-Millionäre gesucht! Abteilung Jülich freut sich auf mehr Studenten Das Boxhorn-Magazin
Viel Andrang auf der Jülicher Kontaktbörse Diplomfeier des Fachbereiches Wirtschaftswissenschaften FH Aachen auf der Hannover Messe 2002 FB Wirtschaftswissenschaften: Vortrag des Staatssekretärs Dr. Manfred Overhaus Wer langsam sinkt gewinnt! Modellflugwettbewerb am FB Luft- und Raumfahrttechnik Neue Gleichstellungsbeauftragte an der FH Der Dingsbums kommt! Neues aus der Bibliothek Eindrücke einer Chinareise von Professor Dietmar Castro Sub-art auf der „boot“ 2002 Ehrensenator Willy Folgmann Personal-Info Fachhochscule vertieft Kooperation mit Chile „Symposium on International Collaboration“ in Izmir Unsere Partnerhochschulen vorgestellt - Coventry University/Großbritannien Fachhochschule goes „Down Under“ An der FH ist Musik drin Tag der offenen Tür Jülich Professor Günter Korte wurde 70! Die Bologna-Erklärung und ihre Folgen Ausbildungsgang „Entrepreneurship“ Technisches Recht und vieles mehr Ausbau des Alumninetzwerkes: Der Rektor hilft mit Zehn Jahre Förderkreis Baubetrieb
Energiecontrolling an der Fachhochschule Aachen Solar-Institut Jülich: Ziele und Philosophie Forschung und Entwicklung Anwendung und Verbreitung Beratung und Information Ausbildung und Schulung Projektbeispiele Nowum-Energy Ressourceneinsparung auf dem Solar-Campus Jülich Fachtagung: Energie-Management Pilotprojekt: Umrüstung von Hörsälen mit moderner Gebäudesystemtechnik
Forschungs- und Technologietransfer - Wege in die Wirtschaft Neu entwickelte Software für Datenschützer im Einsatz Den Stempel aufgedrückt - Gütesiegel für Studiengänge Aufgestiegen - Fachhochschulen spielen in der ersten Liga Arbeitsbelastung - Viele Studenten kapitulieren vor der Regelstudienzeit 100 Jahre Ingenieurausbildung Prof. Schiffers - jede Menge Musik im Blut Prof. Dr. Mang - Professor mit Markenzeichen Prof. Dr. Ing. Gerhard Seehausen Prof. Dieter Rehder über Aufgaben und Ziele im Fachbereich Design Prof.Dr.-Ing. Gregor Krause jung, dynamisch, voller Tatendrang Studierende des Fachbereichs Design führen einen Dialog mit Europa ZARM-Förderpreis für Absolventin der FH Aachen Personal-Info Leinen los für die Gorch Frog Wildnisinsel inmitten der Stadt Die FH Aachen hat gewählt Kritik an Studiengebühren Das neue Corporate Design der Stadt Aachen Rachel MdB: Schnelle Hilfe für FH Aachen Landesrektorenkonferenz an der FH Aachen Nutzung alternativer Energiequellen wird immer wichtiger Zukunftswerkstatt Biosensorik Ballone und Luftschiffe aus Sicht der Rechtswisschenschaft HBZ-Informationsdienst Tag der Forschung