Refine
Year of publication
- 1997 (220) (remove)
Institute
- Fachbereich Medizintechnik und Technomathematik (36)
- Fachbereich Elektrotechnik und Informationstechnik (34)
- Fachbereich Wirtschaftswissenschaften (34)
- Fachbereich Energietechnik (31)
- Fachbereich Chemie und Biotechnologie (25)
- Fachbereich Maschinenbau und Mechatronik (20)
- Fachbereich Luft- und Raumfahrttechnik (16)
- Fachbereich Gestaltung (8)
- Solar-Institut Jülich (8)
- Fachbereich Bauingenieurwesen (5)
Document Type
- Article (154)
- Book (27)
- Part of a Book (15)
- Conference Proceeding (12)
- Patent (9)
- Report (2)
- Doctoral Thesis (1)
Keywords
- Wind Tunnel (3)
- Finite-Elemente-Methode (2)
- Flight Test (2)
- Pitching Moment (2)
- Wave Drag (2)
- Aerodynamic Drag (1)
- Certification Rule (1)
- Drag Reduction (1)
- ELISA (1)
- Effektives Lernen (1)
Museen und neue Medien
(1997)
Veränderte Anforderungen an eine europäische Standardisierungspolitik in der Telekommunikation
(1997)
Anwendung des Haustürgeschäftewiderrufsgesetzes unter Angehörigen (BGH, Urteil vom 17.09.1996)
(1997)
The Lehrstuhl für Wärmeübertragung und Klimatechnik at the Aachen University of Technology operates several test facilities to investigate fundamentals of heat and mass transfer supported by the Deutsche Forschungsgemeinschaft, the Minister für Forschung und Technologie and the industry. In order to get high-resolution and reproselection of hardware components is as critical as the design of software routines to perform successful and accurate measurements. In the following the development of the measurement and control system for three different test facilities is presented and discussed. Special attention is given to the education of students within the framework of laboratories and scientific experiments.
Praezise Streuparametermessungen sind der Schluessel zur Modellierung elektrischer Schaltungen
(1997)
Innovationsreport Großhandel
(1997)
zuerst erschienen in Telekom-Praxis Ausgabe 1997. Von Jürgen Lohr, Jahrgang 1962, beschäftigt mit Softwareentwicklung im Projekt "Interaktive Multimedia" bei der Deutschen Telekom AG, Entwicklungszentrum Berlin. 26 S. Der Beitrag befaßt sich mit dem Thema der universellen Kommunikationsplattform für neue, interaktive, multimediale Dienste und Anwendungen. Ausgehend von den Diensten wird ein Referenzmodell für offene Kommunikation und die Kommunikationsplattform kurz vorgestellt. Desweiteren wird die XAPI mit den Grundbegriffen, den Phasen der Kommunikation und dem Status Modell dargelegt. Ebenfalls werden die realisierten Service Provider erläutert. Abschließend werden zukünftige Vorhaben aus den Standardisierungsprojekten ITU und DAVIC sowie weitere Realisierungen aufgezeigt.
Magister Iuris Communis - Master of European and Comparative Law (LL M) in Maastricht, Niederlande
(1997)
Regenerative Energiequellen
(1997)
In the preceeding chapters on “Son of Concorde, a Technology Challenge” and “Aerodynamic Multipoint Design Challenge” it was explained, that a well balanced contribution of new technologies in all major disciplines is required for realisation of a new Supersonic Commercial Transport (SCT). One of these technologies - usually one of the most important for aircraft-is aerodynamics. Here, the required “pure” aerodynamic technologies are specified in more detail, according to our present knowledge. Increasing insight into the problems may change the balance of importance of the individual technologies and may require some more contributions. We must never confine our knowledge to the knowledge base of an expert at a given time, but must stay open for new insights.
Since certification of Concorde new certification standards were introduced including many new regulations to improve flight safety. Most of these standards are to prevent severe accidents in the future which happened in the past (here: after Concorde’s certification). A new SCT has to fulfill these standards, although Concorde had none of these accidents. But accidents - although they sometimes occurred only for a specific aircraft type - have to be avoided for any (new) aircraft. Because of existing aircraft without typical accident types having demonstrated their reliability, they are allowed to go on based on their old certification; although sometimes new rules prevent accident types which are not connected to specific aircraft types - like e.g. evacuation rules. Anyway, Concorde is allowed to fly based on its old certification, and hopefully in the future will fly as safely as in the past. But a new SCT has to fulfill updated rules like any other aircraft, and it has to be “just another aircraft” [75].