Fachbereich Maschinenbau und Mechatronik
Refine
Year of publication
Institute
- Fachbereich Maschinenbau und Mechatronik (868) (remove)
Document Type
- Article (484)
- Conference Proceeding (207)
- Book (99)
- Part of a Book (32)
- Lecture (21)
- Report (8)
- Bachelor Thesis (5)
- Contribution to a Periodical (3)
- Doctoral Thesis (2)
- Master's Thesis (2)
Keywords
- Rapid Prototyping (8)
- Rapid prototyping (6)
- Übungsklausur (5)
- Additive manufacturing (4)
- Gamification (4)
- Fertigungsverfahren (3)
- Mikrosystemtechnik (3)
- Regelungstechnik (3)
- SLM (3)
- additive manufacturing (3)
During the development process of a complex technical product, one widely used and important technique is accelerated testing where the applied stress on a component is chosen to exceed the reference stress, i.e. the stress encountered in field operation, in order to reduce the time to failure. For that, the reference stress has to be known. Since a complex technical product may fail regarding numerous failure modes, stress in general is highly dimensional rather than scalar. In addition, customers use their products individually, i.e. field operation should be described by a distribution rather than by one scalar stress value. In this paper, a way to span the customer usage space is shown. It allows the identification of worst case reference stress profiles in significantly reduced dimensions with minimal loss of information. The application example shows that even for a complex product like a combustion engine, stress information can be compressed significantly. With low measurement effort it turned out that only three reference stress cycles were sufficient to cover a broad range of customer stress variety.
STEP bietet mehr
(1992)
Abschlussbericht zum Zeichnungssystem Freedraft zur rechnerunterstuetzten Zeichnungserstellung
(1977)
Rechnerunterstuetzte Aufbereitung von Finite-Elemente-Rechenmodellen -Erstellen der FEM-Netzwerke
(1977)
Rechnerunterstuetzte Aufbereitung von Finite-Elemente-Rechenmodellen-Erfassung der Bauteilgeometrie
(1977)
Hybride Produktionssysteme
(2011)
Während die virtuelle Produktentstehungskette große Gestaltungsfreiräume bietet, ist die reale Produktentstehungskette durch wesentlich mehr Randbedingungen gekennzeichnet, die nicht oder nur ansatzweise beeinflussbar sind. Die Realisierung des aus logistischer Sicht optimalen One-Piece-Flow bei gleichzeitiger Steigerung von Flexibilität und Produktivität sowie des Verschiebens der Grenze des technologisch Machbaren müssen in zukünftigen Forschungsansätzen gleichermaßen betrachtet werden. Die Grenzverschiebung auf Basis der Integration von Technologien ist dabei ein viel versprechender Ansatz, der es in vielen Fällen ermöglicht, in allen genannten Zielrichtungen gleichermaßen Potentiale zu erschließen.