Article
Refine
Year of publication
- 2024 (35) (remove)
Institute
- Fachbereich Medizintechnik und Technomathematik (13)
- Fachbereich Wirtschaftswissenschaften (7)
- INB - Institut für Nano- und Biotechnologien (7)
- Fachbereich Luft- und Raumfahrttechnik (6)
- Fachbereich Chemie und Biotechnologie (5)
- ECSM European Center for Sustainable Mobility (4)
- IfB - Institut für Bioengineering (3)
- Fachbereich Elektrotechnik und Informationstechnik (2)
- Nowum-Energy (2)
- Arbeitsstelle fuer Hochschuldidaktik und Studienberatung (1)
Document Type
- Article (35) (remove)
Keywords
- Hot S-parameter (2)
- 1P hub loads (1)
- 3-D printing (1)
- ABE (1)
- Acid crash (1)
- Active humidity control (1)
- Acyl-amino acids (1)
- Acylation (1)
- Aeroelasticity (1)
- Ageing (1)
- Aminoacylase (1)
- Anatomy (1)
- Architektur (1)
- Bio-inspired systems (1)
- Biocatalysis (1)
- Biological hydrogen (1)
- Biosurfactants (1)
- Boundary integral equations, (1)
- Butanol (1)
- C. acetobutylicum (1)
- Capacitive model (1)
- Carrier solvents (1)
- Centrifugal twisting moment (1)
- Chaperone (1)
- Circuit simulation (1)
- Complex-valued eigenvalues (1)
- Constitutive model (1)
- DAC (1)
- Damage mechanics theory (1)
- Dark fermentation (1)
- Deutschland (1)
- Discontinuous fractures (1)
- E. coli detection (1)
- Eigenvalue trajectories (1)
- Electrochemical impedance spectroscopy (1)
- Electronic cigarettes (1)
- Enzyme coverage (1)
- Exponential Euler scheme, (1)
- Extension–twist coupling (1)
- Fault detection (1)
- Field-effect biosensor (1)
- Flutter (1)
- Free-base nicotine (1)
- Fuel cell (1)
- Furnace (1)
- Fusion (1)
- German (1)
- Germany (1)
- Health management system (1)
- Hydrolysis (1)
- Impedance analysis (1)
- Interior transmission problem (1)
- Lifting propeller (1)
- Low field NMR (1)
- MOS (1)
- Master stamp (1)
- Metabolic shift (1)
- Mode converter (1)
- Modeling (1)
- Multianalyte detection (1)
- Muscle (1)
- Musculoskeletal system (1)
- Non-model-based Evaluation (1)
- Non-parallel fissures (1)
- Nonlinear eigenvalue problems (1)
- Obstacle avoidance (1)
- Online diagnostic (1)
- Organic waste (1)
- P2G (1)
- PEM fuel cell (1)
- Parabolic SPDEs (1)
- Path planning (1)
- Penicillin (1)
- Photolithographic mimics (1)
- Physiology (1)
- Plasma (1)
- Plasma diagnostics (1)
- Pre-culture (1)
- Pretreatment (1)
- Propeller whirl flutter (1)
- Quartz crystal microbalance (1)
- Raman spectroscopy (1)
- Relative air humidity (1)
- Surface imprinted polymer (1)
- Trapeze effect (1)
- Uniaxial compression test (1)
- Unmanned aerial vehicles (1)
- Unsteady aerodynamics (1)
- Wasserbau (1)
- Wasserwirtschaft (1)
- Weak organic acids (1)
- aquaculture (1)
- artificial olfactory image (1)
- biodegradable polymers (1)
- biomethane (1)
- bubble column (1)
- carbon dioxide removal (1)
- catalytic metal (1)
- chip-based sensor setup (1)
- climate neutrality (1)
- coupled Néel–Brownian relaxation dynamics (1)
- direct air capture (1)
- economics (1)
- electrical conductivity of liquids (1)
- electronic nose (1)
- field-effect structure (1)
- frequency mixing magnetic detection (1)
- gas sensor (1)
- glycine (1)
- hydrogels (1)
- hydrogen peroxide (1)
- impedance spectroscopy (1)
- key performance indicators (1)
- large language models (1)
- light-addressing technologies (1)
- magnetic biosensing (1)
- magnetic nanoparticles (1)
- magnetic relaxation (1)
- metal-oxide-semiconductor structure (1)
- methanation (1)
- microfluidics (1)
- micromagnetic simulation (1)
- micronutrients (1)
- negative emissions (1)
- optical spore trapping (1)
- plug flow reactor (1)
- polyaspartic acid (1)
- rollout (1)
- scanned light pulse technique (1)
- semantic role labeling (1)
- speaker attribution (1)
- sterilization conditions (1)
- superabsorbent polymers (1)
- swelling properties (1)
- temperature (1)
- thermometry (1)
- visualization (1)
Bald eine Dekade ist es her, dass diese annähernd mantraartig wiederholte Phrase Unternehmen zur Umsetzung datenschutzrechtlicher Vorgaben incentivierte. Was ist davon geblieben? Nur wenige in Deutschland verhängte Bußgelder erreichten Millionenhöhe. Hintergrund ist (auch) das deutsche Ordnungswidrigkeitenrecht, welches in einem Spannungsverhältnis zu den Vorgaben der DS-GVO steht. Ein Bußgeldbescheid der Berliner Datenschutzaufsicht gegen die Deutsche Wohnen sollte Auslöser eines langen, fortdauernden Rechtsstreits werden. Auf Vorlage des KG hatte der EuGH in der Rechtssache C-807/21 („Deutsche Wohnen“) erstmals Gelegenheit, sich zur Frage der Bußgeldhaftung zu positionieren.
Seit Ende 2022 prägt das Schlagwort „Künstliche Intelligenz“ (KI) nicht nur den rechtswissenschaftlichen Diskurs. Die allgemeine Verfügbarkeit von generativen KI-Modellen, allen voran die großen Sprachmodelle (Large Language Models, kurz: LLM) wie ChatGPT von OpenAI oder Bing AI von Microsoft, erfreuen sich größter Beliebtheit: LLM sind in der Lage, auf Grundlage statistischer Methoden – eine entsprechende Schnittstelle (Interface) vorausgesetzt – auch technisch wenig versierten Nutzern verständliche Antworten auf ihre Fragen zu liefern. Dabei werden nicht nur umfassend Nutzerdaten verarbeitet, sondern auch auf weitere personenbezogene Daten zugegriffen sowie neue Daten erzeugt. Der Beitrag geht der Frage nach, welche spezifischen datenschutzrechtlichen Herausforderungen sich für Unternehmen beim Einsatz solcher LLM stellen.
Das Thema Datenschutz wurde bei der öffentlichen Auftragsvergabe bislang vor allem in Bezug auf Drittlandtransfers personenbezogener Daten in die USA diskutiert. Jedoch spielt der Datenschutz für das Vergabeverfahren und für die Ausführung datenschutzrelevanter Leistungen generell eine wesentliche Rolle. Gleichwohl herrschen bislang unter öffentlichen Auftraggebern Schwierigkeiten, datenschutzrechtlich relevante Fallkonstellationen zu erkennen, die möglichen Risiken daraus abzuleiten und, sofern dies gelingt, diesen Risiken angemessen zu begegnen. Der vorliegende Beitrag befasst sich mit der datenschutzrechtlichen Verantwortlichkeit, ihren Folgen und den daraus resultierenden Konsequenzen für die Gestaltung von Vergabeverfahren und Vergabeunterlagen.
In this work, we present a compact, bifunctional chip-based sensor setup that measures the temperature and electrical conductivity of water samples, including specimens from rivers and channels, aquaculture, and the Atlantic Ocean. For conductivity measurements, we utilize the impedance amplitude recorded via interdigitated electrode structures at a single triggering frequency. The results are well in line with data obtained using a calibrated reference instrument. The new setup holds for conductivity values spanning almost two orders of magnitude (river versus ocean water) without the need for equivalent circuit modelling. Temperature measurements were performed in four-point geometry with an on-chip platinum RTD (resistance temperature detector) in the temperature range between 2 °C and 40 °C, showing no hysteresis effects between warming and cooling cycles. Although the meander was not shielded against the liquid, the temperature calibration provided equivalent results to low conductive Milli-Q and highly conductive ocean water. The sensor is therefore suitable for inline and online monitoring purposes in recirculating aquaculture systems.
Wer A sagt, muss zumindest im Kaufrecht nicht immer B sagen: Es kommt nicht selten vor, dass sich in einem Kaufvertrag einerseits ein wirksamer Ausschluss der Gewährleistung des Verkäufers für Sachmängel findet, die Parteien aber andererseits gleichwohl eine Beschaffenheitsvereinbarung für bestimmte Eigenschaften vertraglich festlegen. In diesem Problemfeld führt eine aktuelle Entscheidung des BGH zu weiteren Klärungen für die Praxis (BGH, Urt. v. 10.4.2024 – VIII ZR 161/23, MDR 2024, 706). Der folgende Beitrag setzt sich mit den vielfältigen Aspekten der Entscheidung auseinander und erläutert, aus welchen Gründen der BGH dem Käufer einige goldene Brücken für einen Schadensersatzanspruch gebaut hat.
As one class of molecular imprinted polymers (MIPs), surface imprinted polymer (SIP)-based biosensors show great potential in direct whole-bacteria detection. Micro-contact imprinting, that involves stamping the template bacteria immobilized on a substrate into a pre-polymerized polymer matrix, is the most straightforward and prominent method to obtain SIP-based biosensors. However, the major drawbacks of the method arise from the requirement for fresh template bacteria and often non-reproducible bacteria distribution on the stamp substrate. Herein, we developed a positive master stamp containing photolithographic mimics of the template bacteria (E. coli) enabling reproducible fabrication of biomimetic SIP-based biosensors without the need for the “real” bacteria cells. By using atomic force and scanning electron microscopy imaging techniques, respectively, the E. coli-capturing ability of the SIP samples was tested, and compared with non-imprinted polymer (NIP)-based samples and control SIP samples, in which the cavity geometry does not match with E. coli cells. It was revealed that the presence of the biomimetic E. coli imprints with a specifically designed geometry increases the sensor E. coli-capturing ability by an “imprinting factor” of about 3. These findings show the importance of geometry-guided physical recognition in bacterial detection using SIP-based biosensors. In addition, this imprinting strategy was employed to interdigitated electrodes and QCM (quartz crystal microbalance) chips. E. coli detection performance of the sensors was demonstrated with electrochemical impedance spectroscopy (EIS) and QCM measurements with dissipation monitoring technique (QCM-D).
New insights into the influence of pre-culture on robust solvent production of C. acetobutylicum
(2024)
Clostridia are known for their solvent production, especially the production of butanol. Concerning the projected depletion of fossil fuels, this is of great interest. The cultivation of clostridia is known to be challenging, and it is difficult to achieve reproducible results and robust processes. However, existing publications usually concentrate on the cultivation conditions of the main culture. In this paper, the influence of cryo-conservation and pre-culture on growth and solvent production in the resulting main cultivation are examined. A protocol was developed that leads to reproducible cultivations of Clostridium acetobutylicum. Detailed investigation of the cell conservation in cryo-cultures ensured reliable cell growth in the pre-culture. Moreover, a reason for the acid crash in the main culture was found, based on the cultivation conditions of the pre-culture. The critical parameter to avoid the acid crash and accomplish the shift to the solventogenesis of clostridia is the metabolic phase in which the cells of the pre-culture were at the time of inoculation of the main culture; this depends on the cultivation time of the pre-culture. Using cells from the exponential growth phase to inoculate the main culture leads to an acid crash. To achieve the solventogenic phase with butanol production, the inoculum should consist of older cells which are in the stationary growth phase. Considering these parameters, which affect the entire cultivation process, reproducible results and reliable solvent production are ensured.
Biomass from various types of organic waste was tested for possible use in hydrogen production. The composition consisted of lignified samples, green waste, and kitchen scraps such as fruit and vegetable peels and leftover food. For this purpose, the enzymatic pretreatment of organic waste with a combination of five different hydrolytic enzymes (cellulase, amylase, glucoamylase, pectinase and xylase) was investigated to determine its ability to produce hydrogen (H2) with the hydrolyzate produced here. In course, the anaerobic rod-shaped bacterium T. neapolitana was used for H2 production. First, the enzymes were investigated using different substrates in preliminary experiments. Subsequently, hydrolyses were carried out using different types of organic waste. In the hydrolysis carried out here for 48 h, an increase in glucose concentration of 481% was measured for waste loads containing starch, corresponding to a glucose concentration at the end of hydrolysis of 7.5 g·L−1. In the subsequent set fermentation in serum bottles, a H2 yield of 1.26 mmol H2 was obtained in the overhead space when Terrific Broth Medium with glucose and yeast extract (TBGY medium) was used. When hydrolyzed organic waste was used, even a H2 yield of 1.37 mmol could be achieved in the overhead space. In addition, a dedicated reactor system for the anaerobic fermentation of T. neapolitana to produce H2 was developed. The bioreactor developed here can ferment anaerobically with a very low loss of produced gas. Here, after 24 h, a hydrogen concentration of 83% could be measured in the overhead space.