Refine
Year of publication
Document Type
- Article (617)
- Conference Proceeding (280)
- Book (111)
- Part of a Book (61)
- Patent (15)
- Report (9)
- Other (8)
- Contribution to a Periodical (6)
- Doctoral Thesis (6)
- Video (1)
- Poster (1)
- Review (1)
Has Fulltext
- no (1116) (remove)
Keywords
- Enterprise Architecture (5)
- MINLP (5)
- Engineering optimization (4)
- Digitale Transformation (3)
- Digitalisierung (3)
- Gamification (3)
- Literaturanalyse (3)
- Optimization (3)
- Powertrain (3)
- Referenzmodellierung (3)
- Robotic Process Automation (3)
- Serious Game (3)
- Technical Operations Research (3)
- Telecommunication (3)
- Autonomous mobile robots (2)
- Competence Developing Games (2)
- Education (2)
- Energy efficiency (2)
- Experimental validation (2)
- Forschungsprozess (2)
Institute
- Fachbereich Elektrotechnik und Informationstechnik (1116) (remove)
A novel method to determine the extruded length of a metallic wire for a directed energy deposition (DED) process using a microwave (MW) plasma jet with a straight-through wire feed is presented. The method is based on the relative comparison of the measured frequency response obtained by the large-signal scattering parameter (Hot-S) technique. In the practical working range, repeatability of less than 6% for a nonactive plasma and 9% for the active plasma state is found. Measurements are conducted with a focus on a simple solution to decrease the processing time and reduce the integration time of the process into the existing hardware. It is shown that monitoring a single frequency for magnitude and phase changes is sufficient to achieve good accuracy. A combination of different measurement values to determine the length is possible. The applicability to different diameter of the same material is shown as well as a contact detection of the wire and metallic substrate.