Refine
Year of publication
- 2010 (24) (remove)
Institute
- Fachbereich Luft- und Raumfahrttechnik (24) (remove)
Has Fulltext
- no (24) (remove)
Document Type
- Article (13)
- Conference Proceeding (5)
- Book (2)
- Part of a Book (2)
- Master's Thesis (1)
- Report (1)
Keywords
- avalanche (2)
- Commercial Vehicle (1)
- Common Rail Injection System (1)
- Diesel Engine (1)
- European Transient Cycle (1)
- RAMMS (1)
- Selective Catalytic Reduction (1)
- attitude dynamics (1)
- orbit control (1)
- orbital dynamics (1)
Two- and three-dimensional avalanche dynamics models are being increasingly used in hazard-mitigation studies. These models can provide improved and more accurate results for hazard mapping than the simple one-dimensional models presently used in practice. However, two- and three-dimensional models generate an extensive amount of output data, making the interpretation of simulation results more difficult. To perform a simulation in three-dimensional terrain, numerical models require a digital elevation model, specification of avalanche release areas (spatial extent and volume), selection of solution methods, finding an adequate calculation resolution and, finally, the choice of friction parameters. In this paper, the importance and difficulty of correctly setting up and analysing the results of a numerical avalanche dynamics simulation is discussed. We apply the two-dimensional simulation program RAMMS to the 1968 extreme avalanche event In den Arelen. We show the effect of model input variations on simulation results and the dangers and complexities in their interpretation.